Calypso Fox Street car Quest for 6's Hydraulic 388ci GTR98
#62
TECH Fanatic
Thread Starter
Been busy with holidays and a vacation. Polished it up a bit. I got a lot of the grime and scuffs off from it. I need to cut it a little deeper when its ready to come out.
?Stacking up some stuff here and there.
Down to the shortblock, fuel and cooling system.
?Stacking up some stuff here and there.
Down to the shortblock, fuel and cooling system.
#63
Still looks good, a microfiber pad some good compound will get it. I use IGL and their compound is dope with an MF cutting pad or rotary/wool. My TA gets compound/polish/coating next.
#64
TECH Fanatic
Thread Starter
Finally got the axle narrowed and then measured for axles. Slammed the diff together. I can finally get motivated and get to rocking on the car.
#65
On The Tree
iTrader: (6)
Originally Posted by BlackSS4thgen
Lol every GD thing on that catfish was weighed before and after and I personally LOVED it..
I've thoroughly enjoyed your camaro build, and I'm beyond stoked to see where you go with this.
PM me your shop site, I'll and rock some swag in support. Keep it up Kenny!!!
#66
TECH Fanatic
Thread Starter
I was starting to think you had lost your scale...!
Lol every GD thing on that catfish was weighed before and after and I personally LOVED it..
I've thoroughly enjoyed your camaro build, and I'm beyond stoked to see where you go with this.
PM me your shop site, I'll and rock some swag in support. Keep it up Kenny!!!
Lol every GD thing on that catfish was weighed before and after and I personally LOVED it..
I've thoroughly enjoyed your camaro build, and I'm beyond stoked to see where you go with this.
PM me your shop site, I'll and rock some swag in support. Keep it up Kenny!!!
Northern performance cars on facebook. I dont post too much about it on the business page but I have a little album on my personal page. Add me there if you want. Kenny Dangler.
The following users liked this post:
Heyfred (02-05-2020)
#71
TECH Fanatic
Thread Starter
67644 1,750lb blue tooth pads. I like it well. Just need to be cared for and placed on a flat clean surface. I like them a lot. They are a good value.
#75
TECH Fanatic
Thread Starter
Car is officially fresh and how I would have done it if I started clean from the ground up. Im falling more and more in love with it. 213 pounds knocked out of the bare roller.
The following users liked this post:
SLOW SEDAN (02-10-2020)