Photos of the rides
#21
Retired Street Racer
iTrader: (49)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Thanks Chris. Yeah all of the suspension is listed on my Fquick page, as well as the rest of the parts I have on the car and the weight reduction done to it. It is 3100 with me in it and about a half tank of gas. The lower control arms & panhard rod are aluminum with rod ends, and the rest of the parts are chrome moly with the sway bar having poly bushings for the street. I just ordered my k-member and upper & lower a-arms in chrome moly and rod ended. After that Aerospace drag brakes are going on all four corners and I am getting either a Wolfe single or Burkhart weld-on anti-roll bar. The car should be 2950 with me int it at the start of the next season after all of that and the rest of the weight reduction we have planned. I am going for the stock internal record.
![Happy](https://ls1tech.com/forums/images/smilies/LS1Tech/gr_stretch.gif)
#23
Retired Street Racer
iTrader: (49)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
I will when I am done. We are going to work on it slowly over the winter so I don't go insane sitting on my *** and not making a pass while all of you guys take advantage of your warm climate.
The track doesn't open until March, so we have 3 months to start wrenching and get it all tightened up.
![Grin](https://ls1tech.com/forums/images/smilies/LS1Tech/gr_grin.gif)
#27
8 Second Club
iTrader: (67)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
yeah but i need to buy the aje lower a-arms specifically for my set-up. the struts i got according to AJE require a 1 inch shorter lower a-arm. i didnt know that until i got it all put together with my bmr lowers and with them adjusted as far in as they will go i still have too much negative camber. so if you know anyone looking, i will have the bmr lower a-arms for sale. i will take pics soon.
#32
TECH Veteran
iTrader: (23)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
The Mufflex was modded to fit up in the car. The passenger side of the tunnel was moved in . You cannot see the Mufflex hanging out from any angle. All you can see is the 4 inch tip out from under the rear bumper. The bottom of the pipe is higher than the rear subframe.
I want the car lower but the headers and Spohn crossmember are getting beat up already. It is setup to sit ON THE GROUND! The fuel tank was notched and the minitub done so it could really go down but street driving and the bottom of the car do not agree!
Again thanks, if this car was lighter it would run 10's on motor, drag radials and pump gas. It may still do it...I am almost ready to go back to the track.
David