Dyno Results!!!!
#1
TECH Enthusiast
Thread Starter
iTrader: (3)
Join Date: Nov 2001
Location: Las Vegas, NV
Posts: 687
Likes: 0
Received 0 Likes
on
0 Posts
Dyno Results!!!!
Well, I finally got the car to the dyno after running some decent traps. Here are the numbers.
Motor
386 RWHP
375 RWTQ
N20
545 RWHP
510 RWTQ
These numbers are with stock heads a 228/232 Comp Cam and a TNT 150 shot.
The torque was down because I would try to lay into it and the converter was locked up then it would flash, then lock up causing a dip in the graph.
Motor
386 RWHP
375 RWTQ
N20
545 RWHP
510 RWTQ
These numbers are with stock heads a 228/232 Comp Cam and a TNT 150 shot.
The torque was down because I would try to lay into it and the converter was locked up then it would flash, then lock up causing a dip in the graph.
#3
TECH Veteran
Join Date: Aug 2002
Location: Hartsdale, NY
Posts: 4,055
Likes: 0
Received 0 Likes
on
0 Posts
Re: Dyno Results!!!!
Hey TA:
Did you see this weeks' Two Guy's Garage?
They featured Greg Moser of Moser Engineering...
He helped Sam and Dave install a set or 4;10 rear grears in a F-body 10-bolt....great stuff...
Did you see this weeks' Two Guy's Garage?
They featured Greg Moser of Moser Engineering...
He helped Sam and Dave install a set or 4;10 rear grears in a F-body 10-bolt....great stuff...
#7
TECH Enthusiast
Thread Starter
iTrader: (3)
Join Date: Nov 2001
Location: Las Vegas, NV
Posts: 687
Likes: 0
Received 0 Likes
on
0 Posts
Re: Dyno Results!!!!
Z00,
They are custom made from a shop here in Vegas.
BLUEBYU,
Here is the cam. 228/232 .588/.574 113LSA
Biochem,
I have a Walbro 340 intank pump. I had the stock one, but I was running out of fuel top end even with an inline, it was leaning out.
They are custom made from a shop here in Vegas.
BLUEBYU,
Here is the cam. 228/232 .588/.574 113LSA
Biochem,
I have a Walbro 340 intank pump. I had the stock one, but I was running out of fuel top end even with an inline, it was leaning out.