EPS cam and pacesetter results-updated w/ dyno & idle vid
#1
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
226/234 .598 .601 EPS cam 1 3/4 pace setters and off road ypipe
made 403/377 extremely flat tq curve.
I'm pretty sure it will run low 11's at high1teens or low 120's. I will see tomorrow when I run at midnight madness.
made 403/377 extremely flat tq curve.
I'm pretty sure it will run low 11's at high1teens or low 120's. I will see tomorrow when I run at midnight madness.
Last edited by work in progress; 08-21-2011 at 04:20 PM. Reason: updated w/ dyno & idle vid
Trending Topics
#11
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Didn't run as well as I had hoped (isn't that always the case).
DA3000
1.71 60'
11.91 @ 115
I couldn't launch very hard without spinning, before cam and headers I was cutting 1.6x's
There was only 1 fbody that ran better than me and he was a stock internal car spraying a 150 shot and running 11.4, so I don't feel too bad.
DA3000
1.71 60'
11.91 @ 115
I couldn't launch very hard without spinning, before cam and headers I was cutting 1.6x's
There was only 1 fbody that ran better than me and he was a stock internal car spraying a 150 shot and running 11.4, so I don't feel too bad.
#16
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
3660 with me in it. I need to remove front sway bar, get some skinnies, and go back with better air. I think that would net me some low 11's. On a side note, I only lost once to a full out drag bike, beat a zx6, bolt on 5.0 that made 448 whp (we actually ran very similar times) and a super charged 3v.
Last edited by work in progress; 07-10-2011 at 03:12 PM.