TSP MS3 Dyno, + 100shot.
09-16-2005, 11:40 AM
#1
TECH Enthusiast
Thread Starter
iTrader: (11)
Join Date: Jun 2005
Location: Buford, GA
Posts: 505
Likes: 0
Received 0 Likes
on
0 Posts
TSP MS3 Dyno, + 100shot. Here are the dyno results, a couple pictures, and a video of the nitrous dyno pull. The spike at the beginning of the nitrous is because my purge solenoid is broke and the new on hasnt came yet. he cut it off a little early also since it was manual because the window switch isnt in yet either. Over all not too bad for a 96k stock bottom end. Sorry for the sound in the video the car is crazy loud and we were inside and my camera sucks for videos.
video.... http://www.atldragracing.com/100shot.mov
I was suprised to see that the baseline was almost 400.. 398.7 or something like that. Made okay WOT power, but drivability sucked, its better now, and you can tell the a/f is better.
video.... http://www.atldragracing.com/100shot.mov
I was suprised to see that the baseline was almost 400.. 398.7 or something like that. Made okay WOT power, but drivability sucked, its better now, and you can tell the a/f is better.
Trending Topics
09-16-2005, 01:59 PM
#10
TECH Apprentice
iTrader: (1)
Join Date: Apr 2005
Location: St. Louis
Posts: 351
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by 1badass98
I put 4.10 gears in an lost 20hp.I have a 98 with the same setup
Great numbers buddy.
09-16-2005, 02:59 PM
#15
Teching In
Join Date: Mar 2005
Posts: 15
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by 98SuperSport
I didnt know/think gears would have any power reduction issues. I understand if it is a larger rearend you can lose power but not gears.
Great numbers buddy.
Great numbers buddy.
09-16-2005, 03:11 PM
#16
11 Second Club
iTrader: (20)
Join Date: Jul 2002
Location: Jonesboro, Ga
Posts: 1,988
Likes: 0
Received 0 Likes
on
0 Posts
You will lose horsepower with a higher gear ratio. I didn't think it was anywhere near 20 horsepower, but I guess there can be other factors involved from dyno to dyno, etc.
Peace,
Josh
Peace,
Josh
09-16-2005, 03:25 PM
#17
Banned
iTrader: (19)
Join Date: Jun 2005
Location: chitown
Posts: 1,879
Likes: 0
Received 0 Likes
on
0 Posts
who gives a crap about losing power on the dyno if it's going to make the car way faster??? my car was 430+ rwhp as a 6spd, i put in a 400 trans and an unlocked converter w/ a steal driveshaft and only got 370 at the wheels........ but the car is .3 faster now w/ a relatively tight converter.
09-16-2005, 03:48 PM
#18
10 Second Club
iTrader: (20)
Join Date: Feb 2005
Location: Winston-Salem, NC
Posts: 1,340
Likes: 0
Received 0 Likes
on
0 Posts
I've got the same came and stock 3.42 gears, and the car does not buck, surge or act up at all. Extremely low to extremely high RPM, the car drives like stock.
Just advising everybody that has this cam - it's not the cam thats making the car act up, its a bad tune.
Just advising everybody that has this cam - it's not the cam thats making the car act up, its a bad tune.
09-16-2005, 08:09 PM
#19
TECH Enthusiast
Thread Starter
iTrader: (11)
Join Date: Jun 2005
Location: Buford, GA
Posts: 505
Likes: 0
Received 0 Likes
on
0 Posts
i dont think the tune is bad considering it made 25 more hp then yours. the bucking is very minimal, pretty much a non issue, i daily drive the car. it only happens if you are idling in gear. put a hair pressure on the gas and its gone.
