Post up your turbocharged engine bay!
#62
8 Second Club
iTrader: (26)
Any feedback on this system, been eyeing it for awhile. Getting close to making a decision. I haven't seen many who have it. Looks like they do high quality work which is a plus. Always wondered why the header configuration is different from side to side? How did that GT55 do for you thru the air to air? Was that on a 346" engine?
#64
Why not? I mean aside from why I actually am there's no reason not too for added assurance, other than the money end...
However, the main reason I am is because I like to do some road racing and I will swap the springs to run like 3 psi, instead of 15. No way in hell I could go that low on a single mv-s wastegate.
#66
11 Second Club
iTrader: (8)
Join Date: Mar 2007
Location: Windsor, Ontario Canada
Posts: 569
Likes: 0
Received 3 Likes
on
3 Posts
Almost finished, May put a 90 on the wastegate and move it for ease of changing springs, and have to coat/wrap the headers still.
Motor is being sent out (this is just mock up thats why its all grimmy)
Car is an 1987 Iroc-Z
Jay
Motor is being sent out (this is just mock up thats why its all grimmy)
Car is an 1987 Iroc-Z
Jay
#68
9 Second Club
iTrader: (104)
There work is outstanding, they are just not known in the LS world yet. After the Hot Rod Magazine car is done that will all change. The main reason headers are different because you need top access to the passenger side for plugs driver side is a cake walk from the bottom. The air to air really surprized me. I see 5 to 15* over ambient on the intake temps. Last year the engine was a 410ci. I had an oiling issue that ended my season before I had a chance to lean on it. This year I have an ERL block and a dry sump so I hope to find the limits of this turbo. I think this system would be even better with the GT55 106. I just dont have the money for another turbo right now.
#71
8 Second Club
iTrader: (26)
I figured it was for plug access, but aren't both sides accessible from the bottom? Was last year a 4-bolt set-up? I assume this year is a 6-bolt Superdeck 1. Nice combination of parts, all quality. Top notch builder too. This looks like a real nice build. What are the expectations?
#72
9 Second Club
iTrader: (104)
I got the 6 bolt super deck but I have to wait until this winter to get the 6 bolt heads I want. I really just want to be able to run the local 8.90 index classes consistantly without stressing the setup. I only have an 8.50 cert on the chassis so I wont be able to run faster than that many times without getting in trouble with the track.
#74
TECH Fanatic
iTrader: (19)
Join Date: Sep 2007
Location: houston TX
Posts: 1,497
Likes: 0
Received 0 Likes
on
0 Posts
another reason is that you must mount the WG so that it bleeds off exhaust from both banks of cylinders, if it doesnt then you will see massive boost creep. the bank with the gate will all go out the gate, and the bank without will all go through the turbo.
you can mount the single gate at or after the merge, OR, use pipes to mount a single gate to both banks, OR, run two gates.
you can mount the single gate at or after the merge, OR, use pipes to mount a single gate to both banks, OR, run two gates.