Post up your turbocharged engine bay!
Trending Topics
#11
Banned
iTrader: (18)
Join Date: May 2008
Location: Ol' Kentucky
Posts: 142
Likes: 0
Received 0 Likes
on
0 Posts
Well the rear mount was basically simply for looks! But your a little wrong, the intercooler actually works quite well, even with a 0-100+ mph 18psi pull the IAT stays right with ambient temp outside!! Also after hard pull I have stopped and used a infered temp gun on both the inlet and outlet of the intercooler and there is always a 20-30 degrees difference!
#13
Banned
iTrader: (18)
Join Date: May 2008
Location: Ol' Kentucky
Posts: 142
Likes: 0
Received 0 Likes
on
0 Posts
Its the aeromotive boost referenced regulator, it does have an -8 line for the return only because I had enough -8an line to go from the tank to the engine and back, the return port is actually a -6an hole with a -6 male to -8 male adapter!
#16
On The Tree
iTrader: (2)
Join Date: Jul 2008
Location: Virginia
Posts: 134
Likes: 0
Received 0 Likes
on
0 Posts
Actually I still have some lines and wiring to finish before the swap is complete. But I'm sure when it is done, it probably will have a lot more in it without the filter. But its the biggest diamter one I could find to fit in that small of an area. The filter has a 6" inlet. I guess we will see.
#20
TECH Veteran
iTrader: (17)
Join Date: Mar 2009
Location: Indy
Posts: 4,220
Likes: 0
Received 0 Likes
on
0 Posts
Great setup bro. looks sharp.