ttsscamaro1

I have a 2000 Camaro and need a hood to clear the rmcr supercharger kit they have, it looks great but I dont want to spend all that money and the hood not fit.Has anyone use the sunoco hood with a v2 vortech upgrade?

RS_SS69

iTrader: (31)

If its the SS hood you have to cut out the scoops underneath, you can go aftermarket but the buldge is in the wrong place. We have a few cars here with YSI and we had to cut the hood, shave the top of the blower and lower the k member a half inch for clearence and its still tight.

ttsscamaro1

What cowl hood will bolt on without doing all that? I like the 2 1/2 cowl hood just dont want to shell the cash for something that will not work

YSILT1

iTrader: (6)

I have seen several from VFN fit. Like there 2 " Cowl.

RS_SS69

iTrader: (31)

A VFN cowl should clear it alot better but all the cars here have stock hoods.

ttsscamaro1

I like the 2 inch smooth hood from vfn it looks good but the stock ss hood does not fit at all its been cut almost paper thin need about another half inch

LSpeed1

iTrader: (2)

i hoping to be in your same position soon.
i plan on going with a harwood 3" cowl.

ttsscamaro1

The only problem with the harwood is they never fit right.

LSpeed1

iTrader: (2)

i wasnt aware of that.
i know they require a bit of cutting, but nothing major.
if not then i would go sonoco. but im honestly not sure if it would clear the hood.
keep us posted on your decision.

TransAmatt99

iTrader: (24)

any updates?? I have the glasstek 4" cowl will the ysi fit under it?

phatasp

iTrader: (11)

I was talking to a member on here and he was saying that rmcr said that the ultra z hood would work. He was,nt happy

TransAmatt99

iTrader: (24)

ya I dont really care for the ultra Z, and since I have a grand already wrapped up in this hood I dont want to have to change it out again and go through that nightmare.