Mr.Big

Looks beautiful Mark/IPS!

Are you guys planning on using any of the "heat shielding" similar to the design Nick Yoskin installed on his? Seems like the cold side (I.C.) would benefit from the hot side being covered or maybe even the hot and cold side...

The Alchemist

iTrader: (19)

I like how you kept the intercooler in the engine bay. Very impressive setup.

I hope it lives up to expectations.

Zmg00camaross

iTrader: (11)

How much can you cram under a stock hood = **** ton. Amazing work to fit this into the engine bay of a C6

atomicfusion

We are planning on coating everything at some point, but it will only get so hot in 7 seconds.

T76s10

iTrader: (6)

This makes me realize how poor I really am.

mdhmi

iTrader: (1)

Something tells me 7s isn't the goal.

xX-Z28-Xx

iTrader: (4)

V-seriesTech

iTrader: (5)

...if that isn't menacing,..I don't know what is.

Thats a bad bitch right there. Well done.

LS1PUNK

iTrader: (5)

Something about those fog lights doesnt look right.

atomicfusion

Well... we all have to have goals right???

jbhotrod

How much longer?!

91sonomast

Question, where they hell does the radiator go? lol

Boosted3rdGen

iTrader: (8)

I'm guessing the engine will cooled via an ice/water reservoir.

atomicfusion

We are actually going to remote mount a radiator and have a backup system coming from the ice box....

atomicfusion

Phil99vette

iTrader: (11)

Looks killer, what are you going to do to keep the heat from the exhaust out of the intercooler?

Fb0dy0nly

iTrader: (10)

Gunna be a lot of heat from those headers tho, any reason why you didnt put the IC in the passenger area or did I miss something about that? I like it in the engine bay but its gunna be a tight fit for sure. Good luck with the build Mark.

91sonomast

Granted the engine is going to run a little before he runs, but in total the engine probably runs for what, a minute or two at a time since he is no longer going to be driving it on the street. It's not gonna get very hot in there even if he doesn't do a heat shield or anything.

atomicfusion

We put it in the engine bay to allow for the system to pressurize quicker... I wanted to do anything I could to increase spool time and since we won't have an extra 6' or so of piping to pressurize I think it will make the system more effecient. I also wanted as few bends as possible on the system.

Much of this design was done in collaboration with people that know a LOT more than me... Ultimately we are hoping to make this system work as well as it can.

Boosted3rdGen

iTrader: (8)

Fixed