67 Nova TT build
#61
Got trans put in. I moved the motor back two inches which got my intake set up to fit under the 2 inch cowl hood and my IC and rad, fan and a/c condenser to fit. But now I have to reconfigure my steering shaft as it is right in the way of my down tube.
Moved back, plenty of room
Little massaging with the air hammer and no more clearance issues
I want to modify the cross member, going to add loops that the exhaust will run through.
Moved back, plenty of room
Little massaging with the air hammer and no more clearance issues
I want to modify the cross member, going to add loops that the exhaust will run through.
#69
Beautiful car, but i would be a little worried about over heating. U have a a/c condenser and a huge intercooler with only a little bit of ur rad showing. U should have had 417 make u one of those atow intercoolers that fit the holley intake.
#71
got a PM from someone which reminded me of this thread. I had to tuck it away but now back at it strong. Made a munch of changes which required new body work and fabrication. Really hope to have it on the street this summer.
dash fabed up and ready for paint
bumpers reshaped, bolt holes filled in and exhaust cut outs
new hood with vents cut in. the pockets were a PIA
trunk release modified
lots and lots of other stuff going on so I'll start updating again.
dash fabed up and ready for paint
bumpers reshaped, bolt holes filled in and exhaust cut outs
new hood with vents cut in. the pockets were a PIA
trunk release modified
lots and lots of other stuff going on so I'll start updating again.
#72
I did not cut the fire wall. I used adjustable mounts and had to modify them. I also slightly modified the trans tunnel. Everything clears with little room.
Although I think it will be fine I am no looking at installing the new brushless spal fans which will give me more room.
Although I think it will be fine I am no looking at installing the new brushless spal fans which will give me more room.