95 Z28 TT 5.3 true street. build
08-28-2012, 01:12 AM
#61
pretty much finished up the down pipes, just needs 02 bungs welded on, which I'll have to get tomorrow. Then they'll get some vht paint and some wrap. Might trim the bottom corners of the bumper a little and rotate the pipes forward, just to make sure the tires wont rub but I'll figure that out once I get the rest of the front suspension done.
08-30-2012, 10:04 AM
#65
You need a special (kind of) fitting for the fuel cell on top if you have the intank pump like I have. PM me if you like I will get you a part number. I just went through this myself.
09-11-2012, 09:23 PM
#67
Havent done a whole lot to the car, I finished up a motor/trans/rear swap on my roomate's c5 and tuned it. I did however finish smoothing the firewall, stripped, primed and painted the engine bay. Still waiting on my wire harness for the car, as well as my pushrods from Thunder Racing.
09-26-2012, 09:29 PM
#73
Here's how the car sits currently... pulled the 10 bolt out to get the 12 bolt in there along with the nasty perf fuel cell. made all the radiator hoses and feed/drain lines. All thats left is a front brake lines, wiring in the body harness when I get it from racewire solutions (should be next week) and running the feed/return lines from the tank.
09-27-2012, 03:59 PM
#76
battery is in the trunk, with a cutoff switch, and the coolant over flow is going to be mounted under the headlights. There is a 2 1/2 hole behind the intake manifold where the harness will come through, the pcm and fuses will be mounted in the car on the firewall.
