So, I had 3bar ls1 style map sensor that took a **** (efi source) and was wondering if could use the brick style gm 3bar without tuning? I would have to haul my truck back to the tuner if so. When i bought the efi source one, they told me any gm 3bar values would work; since they had no cal data with the sensor.

 

i have used the same values for ebay, efi source, GM actual parts etc without a problem

what is the problem with EFI source and did you call mike and say its not working, i am SURE he will gladly replace it.

 

the sensor came apart, was not epoxied properly, and i plugged it up with too much gorilla glue putting it back together. i will just order 2 of them just in case this happens again. kinda sucks cause i wanted to drive it at the cruise we had yesterday.

 

epoxy them B4 the initial install.

 

epoxy them B4 the initial install.
Hose hanging off of it?

 

What values are you guys using? I see quite the mix when searching

 

the sensor came epoxied. yes a hose is hanging off of it, why?

 

305 : 10.33