05 colorado SBE 6.0/C480/4l80e 9.78@143 foot brake 3850lbs
#1421
8 Second Club
iTrader: (13)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Weird it was making 24 hp per psi going from 4-10lbs. Then 20 hp per pound from 10-13lbs, Then 28hp per lb from 13 to 15lbs! Does that mean the timing was probably not high enough at 4-13lb range? Or do you think the compressor wasn’t at its happy spot on the map in the lower boost levels?
Can you setup the boost to come in at X rpm (or MPH) with the Holley like you can with the MS3? Seems like if you could pour on the boost over 6k you could get your peaky 4 digit power level dyno number without pounding on it so hard at low RPM. Should be a lot easier on things if you only make “big” power well above peak torque.
Can you setup the boost to come in at X rpm (or MPH) with the Holley like you can with the MS3? Seems like if you could pour on the boost over 6k you could get your peaky 4 digit power level dyno number without pounding on it so hard at low RPM. Should be a lot easier on things if you only make “big” power well above peak torque.
#1424
TECH Fanatic
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
![Winky](https://ls1tech.com/forums/images/smilies/LS1Tech/gr_wink.gif)
#1430
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Weird it was making 24 hp per psi going from 4-10lbs. Then 20 hp per pound from 10-13lbs, Then 28hp per lb from 13 to 15lbs! Does that mean the timing was probably not high enough at 4-13lb range? Or do you think the compressor wasn’t at its happy spot on the map in the lower boost levels?
Can you setup the boost to come in at X rpm (or MPH) with the Holley like you can with the MS3? Seems like if you could pour on the boost over 6k you could get your peaky 4 digit power level dyno number without pounding on it so hard at low RPM. Should be a lot easier on things if you only make “big” power well above peak torque.
Can you setup the boost to come in at X rpm (or MPH) with the Holley like you can with the MS3? Seems like if you could pour on the boost over 6k you could get your peaky 4 digit power level dyno number without pounding on it so hard at low RPM. Should be a lot easier on things if you only make “big” power well above peak torque.
yes, it has 4 different rods in it, and 100K mile rings and a fresh harbor freight 3 stone hone
#1432
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Hey denmah, in one of the vids you mentioned something about Cameron's fix that lowered trans. temp. Can you elaborate? I just ran into an issue with reduced flow to the cooler. Lost the trans. but hoping to avoid it in the future.