Here's mine.

Btw that Griffin rad is a beast. Have one on mine.

 

Attachments are being gay, here it is.

 

No they're built by oneguysgarage

 

Any closer pics of the Hotside?

 

Here you go. I ended up cutting a notch in to the gram, and building a bracket to support the turbo in that notch. It's working well.



Had to notch for the oil return too.

 

Thanks for the pics.

 

 

Is that the hi or mid ram? Could you post some pics from the side about fender level?? I'm going to put one on my car, courious as to how far it's gonna stick up past the hood.

 

Hi Ram, intake off right now. This is the only other pic right now

 

 

Thanks man, that really doesn't stick up as high as I thought it would. Aje k member? How much of a cowl on the hood?

I'm doing that air to water intercooler under the plenum.

 

To the OP - are you looking to dump the exhaust under the hood/front of the car or run the downpipe out the back?

 

Heres my junk
Flipped manifolds, equal length crossover, single tial gate, turbo braced on the passenger side head.

I like the turbo facing forward, i can remove the headlight and the turbo is right there.
It does make a downpipe a bit of a challenge though.

 

Thats how I was thinking of mounting mine, what turbo is that?

 

Precision 7675

 

What water pump is that and did you tap it for a temp sensor?

 

Its an fbody water pump with a different thermostat housing that comes out straight instead of at an angle

The top of the pump is tapped for the coolant temp guage in the dash.
Usually shows a few degrees warmer than the datalog/ms3 temp that usesthe factory sensor in the head.

 

Thanks for all the awesome ideas.

 

This is what we came up with for my car