that goat!!!!!
STS on a 2004 GTO almost done
Thread Starter
LS1Tech Sponsor
iTrader: (12)
Joined: Nov 2001
Posts: 14,865
Likes: 6
From: Bridgewater,Ma
STS on a 2004 GTO almost done We are almost done tuning in the preproduction GTO kit from STS.This kit is awesome.The fit and finish is great.The car is an A4 with a 3200rpm stall and small Cam.There is no lag!You can brake boost it to any boost level for launch!Just would like to thank STS for there setup and great customer service in getting everything I needed in time 
This kit is extremely quiet inside the car also.Well,till your under boost
This kit is extremely quiet inside the car also.Well,till your under boost
Last edited by Slowhawk; Nov 27, 2009 at 04:59 PM.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Wow that looks great, I posted a few days ago about STSing an '05 GTO, looking from the piping under the car the only thing STS will have to change is the tune, all the hardware from the '04 looks like it should marry up just fine to the '05. And if STS does make a kit for the '05 man it is sooooo mine, I'll go get a GTO and a month later slap on the STS. I can only image the numbers. I ran the math the other day and it should be around 540HP to the ground on the '05. Looks like you should make about 460+HP, am I in the ball park? or is yours a bit madd man?
Thread Starter
LS1Tech Sponsor
iTrader: (12)
Joined: Nov 2001
Posts: 14,865
Likes: 6
From: Bridgewater,Ma
Originally Posted by Jammer
Gotta line it up with the goat we have at east side right now...traditional H/C vs basic STS... should be good!
Thread Starter
LS1Tech Sponsor
iTrader: (12)
Joined: Nov 2001
Posts: 14,865
Likes: 6
From: Bridgewater,Ma
Here is the final dyno.Stock against 8lbs against 10lbs. Tranny wasn't holding too good with the power.
Last edited by Slowhawk; Nov 27, 2009 at 04:59 PM.
12 Second Truck Club
Joined: Feb 2002
Posts: 5,574
Likes: 0
From: Sacramento, CA
Very clean!!!
I like the HP curve
Was the stall chosen when the car was N/A then the STS added or was it built with the STS in mind? IE is it still a 3200 stall or is it effectively higher now with the abundance of TQ?
I like the HP curve
Was the stall chosen when the car was N/A then the STS added or was it built with the STS in mind? IE is it still a 3200 stall or is it effectively higher now with the abundance of TQ?