is a t76 to small?
Only way a 76mm would work , is if was a S76. They use a big turbine wheel. They now have a new LDP "Low drive pressure" wheel. Which is suppose to be made for high backpressure situations.
A standard 76 will drop like a rock on that size of a motor.
A standard 76 will drop like a rock on that size of a motor.
TECH Addict
Joined: Jul 2005
Posts: 2,153
Likes: 3
You will usually find me advocating the use of the T76 on larger displacements than most. I believe that it will do reasonably well up to 400 cid, whereas most say to cut it off at 350 cid. However, 465 cid I even believe is too big for it. The T6 flanged will do better, but ideally you would need a T6 flanged 88 or 91, bigger if it's drag-only.
Mike
Mike
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
Originally Posted by allthrotle
thanks for the input guys. Im only going to be running 14lbs. it should run pretty good with that.
With a 76mm turbo i dont think you would even get to 14psi...... ive been there
LOL with a T6 Flanged 76mm turbo.......With those cubes id go with an 88 or bigger.... for quick spooling and a blast to drive.... id bet over 800rwhp at 14 psi with an 88......
Originally Posted by allthrotle
Do you think a t76 is to small for a 7.5L engine? Im needing opinions. the catch is Im only spinning this thing up to 6500rpm. bore size is 4.352
