fastest stock bottom end turbo or supercharged cars?post your times!
#1
10 Second Club
Thread Starter
iTrader: (38)
Join Date: Jan 2005
Location: Fresno, CA
Posts: 1,411
Likes: 0
Received 0 Likes
on
0 Posts
fastest stock bottom end turbo or supercharged cars?post your times!
well the fastest i have seen in a 10.2
as most of you know im running a 10.6 at 119 on 27 inch QTPS and fastest trap of the day was 128. now i have an anti roll bar and a roll bar/cage and it should help the quater mile times!! so i need to get back to the track on some real slicks (30')and 10 pounds of boost instead of 8.6psi.....
what is your shpeal and how fast are you in the stock bottom end? this is no sticky but ill start a little list for fun for the stock bottom end guys!
as most of you know im running a 10.6 at 119 on 27 inch QTPS and fastest trap of the day was 128. now i have an anti roll bar and a roll bar/cage and it should help the quater mile times!! so i need to get back to the track on some real slicks (30')and 10 pounds of boost instead of 8.6psi.....
what is your shpeal and how fast are you in the stock bottom end? this is no sticky but ill start a little list for fun for the stock bottom end guys!
#5
10 Second Club
Thread Starter
iTrader: (38)
Join Date: Jan 2005
Location: Fresno, CA
Posts: 1,411
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by ninetres
10.5 @120 and fastest trap of the day was 129
jk. 12.3@115 here---> n/a, stock internals, full weight
jk. 12.3@115 here---> n/a, stock internals, full weight
for supercharged or turbo cars!
Trending Topics
#9
8 Second Club
iTrader: (34)
Quite a few guys have run in the 9s on nitrous with a stock bottom end. I ran 10.5x a few years ago with a 100% stock (except for valvesprings) 2000 SS with a P1SC and a 75 shot of nitrous, LS1 intake and all.
Mike Brown may have done 9's it with the Incons, dont remember. My last engine had stock connecting rods but forged pistons and went 9.70s, if only these had better pistons stock..
Mike Brown may have done 9's it with the Incons, dont remember. My last engine had stock connecting rods but forged pistons and went 9.70s, if only these had better pistons stock..
#12
9 Second Club
iTrader: (37)
Mike dont count anyway...he has a lazy eye...hammer toe...and I heard his car never had an Incon kit but a lot of NAWWWWSSS. I think he went 9.89 on his stock bottom end and lingenfelter heads with ONE walbro pump and some alky. If he had it to do over again, I bet he could go 9.7x with his experience gained since then. Now he runs 9.7s shutting down at the 1/8 to do a plug check