AFASTYZFR1

iTrader: (55)

My idler on main drive belt siezed up yesterday.....I put a new one on (on the side of the road....had to remove supercharger) now the new one is squeeking........I got it from napa



any ideas

Only ERO's

iTrader: (19)

Does this make a squeeking sound at a certain rpm range or just all the time? I am haveing a squeeking from 2000-4000 rpms. I am going to try to start with one thing at a time to eliminate it. I think it is one of the pulleys going bad. Others have told me a belt or the alignment of the pulleys. I have subscribed to the thread and just wondering if you can post what it was when you figure it out.

D-Webz

iTrader: (4)

I had the have the same sound. I had my idler siezed up on the dyno. Apparently the bolt became loose on the back side of the pulley.

forcd ind

iTrader: (7)

mine was squeaking pretty bad-i had the d1sc and 8 rib conv.-i installed a new belt, cured the problem

AFASTYZFR1

iTrader: (55)

there was a washer on the backside that was hanging on idler all fixed now and ready for boost

EPP

iTrader: (22)

Good to see you got it up and running. Bob

MadIceV8

iTrader: (12)

Sorry to bring this thread back up but I believe I am having this same issue. Can you clarify what you mean by this washer?

AFASTYZFR1

iTrader: (55)

I had the washer that goes on back side of idler pulley backwards so it was dragging.

I have had trouble with this idler for some reason and have to re-grease it when it starts squeaking. Done it about 3 times in 20k miles.

MadIceV8

iTrader: (12)

I noticed I did the same thing after I asked this... thanks for clearing this up though!

Now I just need to figure out why my BPV doesn't seem to be working since everything is tight yet zero boost .