Remove Axels on 12 Bolt
Thread Starter
Joined: Jun 2008
Posts: 370
Likes: 0
From: Edinburg, Texas
Remove Axels on 12 Bolt I have the wheel, caliper, caliper bracket, Moser Cover, and the Pin in the Center of the Eaton removed. But how do I remove the axel? Apreciate all input. Thanks guys
unlike our 7.5/7.625 10 bolt,the 12 bolt has a retaining plate(4 fasteners) bolted to the housing flange to butt up against the axle bearings which are pressed onto the axle. the axle with bearing comes out of the housing. sometimes it comes out easy,sometimes you need a slide hammer.
A slide hammer is almost always needed. Bob
__________________
ATI ProCharger and Moser Sales 260 672-2076
PM's disabled, please e-mail me
E-mail: brutespeed@gmail.comob@brutespeed.com
https://brutespeed.com/ Link to website
ATI ProCharger and Moser Sales 260 672-2076
PM's disabled, please e-mail me
E-mail: brutespeed@gmail.comob@brutespeed.com
https://brutespeed.com/ Link to website
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
the four bolts are at each end of the axle housing that bolt the entire brake assembly on.and yes you will probably have to use a slide hammer and use it on the axles themselves,All you had to do is drain the oil to remove the axles.
who's 12 bolt ..the factory stuff was C-clip...remove the center pin and push the axles in and remove the C-clips ...aftermarket probably ises ford bearing's remove the 4 retaining bolt and pop the axle out ...slight press fit in the housing ...
