Ziptie

What about mikronite treating the entire housing?

MeentSS02

iTrader: (11)

I'm no expert on Mikronite, but I think they are size limited with that stuff. From what I remember of my conversation with Joe and Amber at T-56 Rebuilds, it was all they could do to get the main cluster mikronited due to its size. There's no way you would fit a rear in there...

Sean Collins

Ring the shop tommorow and I will have the info for who to contact. I have cranks and **** done all the time now. Theu should be able to handle a bare center section. As for an entire housing ???? its a big oven though

Sean Collins

Mikronite treating is a very shallow surface treatment that both hardens and polsihs. the idea behind it is that removing the surface flaws decrease the number f areas for stress risers to cracks( breaks in the material) to being which improves material strength by improving surface finish. Mikrnoiting however will not harden the the material as far as I am aware. I don.t think its a thorugh hardening process like Vapor/ or Ion nitriding.

LorcinLs1

I have the s-60 as well, i have no problems with any noise. It was set up by stange and I installed it. i bought it through Ron @ Vengance, his price was better than going to strange direct. It was a direct bolt in. No problems at all, it was as if the car did the swap for me.

Scott@DrivelineSolutions

iTrader: (22)

No noise from the dented backing plate?

LorcinLs1

no, i fixed that once it was on the car

Tom@SpeedInc

iTrader: (5)

The Strange rear ends we did though group purchase and otherwise have been built and setup by Strange.

z-ya

iTrader: (1)

So Scott are the pinion bearings moving in the housing like they do in my moser 12bolt? If they are the good news is they get better after about 9 ring and pinion sets,
work harden I suppose.