koolrayz

iTrader: (26)

Took my 9" apart today and found this on the passenger side axle (31 spline). Drivers side was only slightly twisted, took a straight edge to see it. I took the locker out two years ago because the splines were showing alot of wear. The locker only engages about 3/4 of an inch of the splines, the spool was about a half inch more. I really hate the way the spool kills my tires.
At this point I figure on moving up to a 35 spline axle. Any venders that would like to PM me a quote? I need 35 spline axles (gun drilled?), new wheel bearings (3.150/1.562), 3.7 P.S. gear set, setup kit (3.062 daytona) new spool or locker I am open to options at this point, please break prices down by item and show delivery charges to 44904. Will be ordering next week.

alamantia

iTrader: (10)

I had the same thing happen on an old bracket car of mine and I switched to summers brothers axles and havent had a problem since. Just my 2 cents

tillery

iTrader: (4)

NIIICCCEEE! how are the axle tubes?

bigsticksupra

iTrader: (3)

what brand axles and 9" ?

koolrayz

iTrader: (26)

Axle housings are fine.
Moser axles and rear. There 5 years old. I guess the transbrake was more than they could take LOL

tillery

iTrader: (4)

well stepping up to 35 splined axles will help cure this but sometimes its another bandaid. I wanted to get my 12 bolt narrowed not for the looks of a deep dish wheel but for the streangth of shorter axles. for my set up I know gun drilled axles are not for me. but my ride isnt as radical as yours. yet.

trigger1

iTrader: (28)

That's cute.

z-ya

iTrader: (1)

Time to call mark williams.

LS1>girlfriend

iTrader: (19)

looks like you have short axles.