Fitting a hatch in a Camaro?
#1
12 Second Club
Thread Starter
iTrader: (2)
Join Date: Jan 2011
Location: Old Bridge, NJ/Corpus Christi, TX
Posts: 1,215
Likes: 0
Received 1 Like
on
1 Post
Fitting a hatch in a Camaro?
Hey guys. Looking for a little imput. I'm gonna be helping my friend out by picking up a hatch for him. My question is, is if I can fit the hatch ( at an angle) into the camaro. I dont really need my hatch to close. Rope can be used to keep it shut. Any tips or opinions are much appreciated...
#6
TECH Resident
iTrader: (21)
Join Date: May 2008
Location: East Brunswick, NJ
Posts: 774
Likes: 0
Received 0 Likes
on
0 Posts
Idk man, cause if you think about it the hatch is the outside width of the car so u
d have to fit that on the inside width. If mike doesn't mind waiting till may 12ish i can bring it up for him.
d have to fit that on the inside width. If mike doesn't mind waiting till may 12ish i can bring it up for him.
#7
TECH Enthusiast
iTrader: (9)
Rob, no worries man. That should be fine. The motor/trans didn't go in yet, as I'm awaiting a replacement K-member and oil pan before sliding it all in. Still got a lot to do--Rear, brake lines, fuel lines, body harness and dash--before bringing her over to Jim/Rob for prep/paint.
Definitely looking forward to seeing you up here again, bud. Get home soon!
Definitely looking forward to seeing you up here again, bud. Get home soon!
Trending Topics
#8
TECH Resident
iTrader: (21)
Join Date: May 2008
Location: East Brunswick, NJ
Posts: 774
Likes: 0
Received 0 Likes
on
0 Posts
yeah buddy. I can't wait to be home man, I'm gonna live up by you ahaha. You should come by my place sometime when I get home and examine my parts cache to see if anything else in there that u can use.