part# for the rubber wiper bumper
#1
TECH Apprentice
Thread Starter
part# for the rubber wiper bumper
Does anyone know the part number for the rubber bumper that the wiper arm rests against? Or even the technical term for it. Any assistance would be appreciated.
#2
Launching!
iTrader: (1)
I don't know the part number, but I do know that there are two different sizes. The driver side is the larger of the two. Using the incorrect size on either side will cause the wipers to smack against either other when they are closed. At a quick glance, they both look the same, same design, but comparing them, they are quite different in size. So, make sure you get the right one for the right side. I picked up a couple at the junkyard to replace mine. They also stand on end, not on their side. On their side, the blades mostly don't contact them and slide right over em. Keep that in mind.
#5
TECH Junkie
iTrader: (104)
I just went thru the parts file pdf & it shows them as 'part of air inlet screen'.
So you can not buy them seperately as GM part numbers.
Best bet is to find a local salvage yard & ask them.
Or email/call some of the other salvage yards.
There are a couple who are LS1Tech sponsor who may be able to help.
#8, part of #10-10299673
#25, part of #24-10246203
For example;
http://www.hawksthirdgenparts.com/93...passenger.aspx
So you can not buy them seperately as GM part numbers.
Best bet is to find a local salvage yard & ask them.
Or email/call some of the other salvage yards.
There are a couple who are LS1Tech sponsor who may be able to help.
#8, part of #10-10299673
#25, part of #24-10246203
For example;
http://www.hawksthirdgenparts.com/93...passenger.aspx