rubbing SLP lid???
#22
TECH Enthusiast
Join Date: Jan 2004
Location: Fairfield, CA
Posts: 611
Likes: 0
Received 0 Likes
on
0 Posts
![](https://ls1tech.com/forums/images/ranks/ls1tech10year.png)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
I have the SLP Lid and stock bellows and my never rubs. Are all you guys driving camaros because maybe my ws6 hood helps it from not rubbing. Just a thought.
#23
TECH Enthusiast
iTrader: (16)
Join Date: Nov 2003
Location: Greensburg, PA
Posts: 560
Likes: 0
Received 0 Likes
on
0 Posts
![](https://ls1tech.com/forums/images/ranks/ls1tech10year.png)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Originally Posted by 2ndGenWs6Owner
I have the SLP Lid and stock bellows and my never rubs. Are all you guys driving camaros because maybe my ws6 hood helps it from not rubbing. Just a thought.
#24
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Mine rubs too!!! I just installed the SLP flow pack and the cold air kit about 2 weeks ago. I thought I was the only one this happened to. I checked and rechecked to make sure that all my parts were in the correct locations and seated properly. I also noticed that the top of the plug on the new SLP MAF sensor slightly rubs too, due to it being slightly rotated counter clockwise to get the notches lined up in the smooth bellows.
Is everyone else using that rubber seal to block off the front of their airbox? just curious.
Is everyone else using that rubber seal to block off the front of their airbox? just curious.
#25
TECH Enthusiast
iTrader: (16)
Join Date: Nov 2003
Location: Greensburg, PA
Posts: 560
Likes: 0
Received 0 Likes
on
0 Posts
![](https://ls1tech.com/forums/images/ranks/ls1tech10year.png)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
Originally Posted by grimSSley
Mine rubs too!!! I just installed the SLP flow pack and the cold air kit about 2 weeks ago. I thought I was the only one this happened to. I checked and rechecked to make sure that all my parts were in the correct locations and seated properly. I also noticed that the top of the plug on the new SLP MAF sensor slightly rubs too, due to it being slightly rotated counter clockwise to get the notches lined up in the smooth bellows.
Is everyone else using that rubber seal to block off the front of their airbox? just curious.
Is everyone else using that rubber seal to block off the front of their airbox? just curious.
#26
TECH Fanatic
iTrader: (7)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
I have the slp lid and bellow and mine doesn't rub. You just have to make sure that the bellow is on the mass air flow and throttle body absolutely as far as it can go. I played with my bellow for 10 minutes til I knew it wouldn't move any farther and haven't had any problems since then. They are correct about the front lip of the lid must go into the air box assemblely, not over it.