NW 92 to 85 MAF
Thread Starter
TECH Enthusiast
Joined: Jan 2010
Posts: 695
Likes: 0
From: Corpus Christi, TX
NW 92 to 85 MAF Hey guys i just installed the new FAST 92 and NW 92 on my car and well i have a volant CAI and 85 maf and the angle is pretty bad i was barely able to get the couple to stay on there. I have a silicone coupler reducer its 4in and 3.75 in. Is there a coupler that has a little angle on it so i can be able to have a flush mount on the MAF?
Stock works good, but if you must have a silicone hose then get a 22* 4" in/out hose. I'd double check the angle difference just to be sure, you can also get 15* 4" in/out hoses.
Last edited by 99Bluz28; Jan 27, 2013 at 02:04 PM.
Thread Starter
TECH Enthusiast
Joined: Jan 2010
Posts: 695
Likes: 0
From: Corpus Christi, TX
did you have to do anything special. Im getting a P0507 code n its idling like around 800 steady so im sure its leaking. I switched out the valley cover bolts to Button head ones that came with the FAST. :/ i test drove it and its all RPM and no speed at all now
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo Thread Starter
TECH Enthusiast
Joined: Jan 2010
Posts: 695
Likes: 0
From: Corpus Christi, TX
i reset it just now, but ill test drive it tomorrow and see if it fixed it. but the idle problem is still bugging me. i have no idea whats going on with it. I may just take it to a local speed shop here and have them Take the FAST off and install it again and see if i did anything wrong.
Thread Starter
TECH Enthusiast
Joined: Jan 2010
Posts: 695
Likes: 0
From: Corpus Christi, TX
it ran fine when i put the 85 maf on. When i put the 85 on i had a new tranny and stall go in so i had Frost tune for it. I wanna say the map sensor too because when i put it in the Intake it was kinda loose in there. Idk if the FAST map hole is a little bigger or what but it just popped in and was loose.