Spirals to Quiet down Speed Engineering True Duals
#1
12 Second Club
Thread Starter
Spirals to Quiet down Speed Engineering True Duals
Hey y'all I was wondering which spirals people had used to quiet down their speed engineering true dual set ups, also where they put them. If anyone has gone this route did they use 3" O.D. spiral(s) (seen some on summit racing site) and just grind them a bit to fit?? Any help or tips would be greatly appreciated.
***Note I have an M6 H/C car and I'm just about to install this exhaust system; is it really that loud to require spirals?? I'm not trying to wake the dead when I leave for work in the morning type thing, right now I have 1 7/8" headers into your typical Texas speed 3" Y pipe. Any advice is appreciated.
Thanks again y'all!!
***Note I have an M6 H/C car and I'm just about to install this exhaust system; is it really that loud to require spirals?? I'm not trying to wake the dead when I leave for work in the morning type thing, right now I have 1 7/8" headers into your typical Texas speed 3" Y pipe. Any advice is appreciated.
Thanks again y'all!!
#3
12 Second Club
Thread Starter
Thank you for sharing that! I had looked around and saw on other posts that Hio put some spirals in, just wanted to see which ones!! Again I appreciate that!