I usually only post these for local guys in AZ, but figured I could let you all see! Its a true dual system over the axle out the stock CME tip with XR1 mufflers and BETTER ground clearance than stock! nothing can be seen under the car or from out back!










Enjoy!

 

That looks amazing... any idea on the cost of this setup?

 

we charge $1200 out the door, however we dont mail order or sell any way but locally as we do a few modifications to the chassis to achieve that kind of ground clearance!

and before I get jumped on, this isnt an advertisement Just showing off a bit

 

Easy on pics and price quoting there. Dangerous threads like these can educate the board about other products out there besides those sponsors sell...

Seriously - VERY nicely done! A little overkill on the mufflers - I would have done bullets, but that's just me. Looks great - and a fair price too!

 

we used Borla XR1s... I personally hate the sound of bullets, and the XR1s are lighter, quieter and flow the best of any muffler I know of... we do on average 2 sets of true duals a week with the XR1s, and a once in a while some get the bullets but they end up being too loud and switch to the XR1s Plus the sound of the XR1s is INCREDIBLE! no resonation inside the car like the bullets

 

That is the most awesome true dual I have ever seen. Sweet job! Hey, is that a custom bar you have running over top of the panhard bar? It doesn't look stock, and I have not seen any replacements. It would be nice to have more clearance back there...

 

its a BMR upper panhard rod

 

It's a relocation bar and bracket made by BMR for true dual clearence. It's on there website.

 

I can't believe I missed it. Sweet.

 

I did an exhaust like that to my first car 85 Iroc-z back in the 1989.But yours looks better than the one i ran.Nice job man!!!

 

They do sound great, but they're just a little big back there... When I said bullets, I didn't mean Dynomax bullets - but Flo-Pro Twisters, which are bullet sized. If you're not familiar with them, they're a 'spiral' flow bullet. Sound nearly identical to the XR1's(we've done both), no drone, smaller and easier to fit, and cheaper.

Again - EXCELLENT system!

 

sounds clip?

 

I will have to try a set... any links to where they are found ?

 

it was taken on a digital camera so it wasnt that great, and its over 20 meg

 

That looks like a BMR upper panhard bar.

Mike

 

Wow, great work. It seems that everything that comes out of the az power shop is first class. I'll have to stop by and check it out next time I'm in the area on business.

Jeff

 

Damn I bet that sounds sweet! Can we get a sound clip? That undercarriage could use a wash

 

Man...I love looking at those pics. They are better than ****.

 

Gee, now all I need to do is send my car to Arizona....that should only run me about $3600 to ship off-island and return! Drats!!!


Looks very nice, and think, no rubbing, can use damn near any Torque arm, and driveshaft loop you wanted to, bastards.

 

Looks damn good but that a whole lot of money