I was looking for alist of tools that I'm going to need to do this and so far the only thing I can find is a list from the guide for the MAC headers. Will I need th esame stuff? Is there anything in this list that I don't need or something that's missing? Thanks.

Ratchets
1/4 with extension
3/8 with extension
breaker bar

Sockets
6,8,10,13,15mm
10mm d.w.
5/8 spark plug socket

Wrenches
10,13mm
5/16,7/8

Miscellaneous
4 ton jack & jack stands
Flat head screwdriver
8mm x 1.25 tap
Safety glasses
anti-seize compound

 

gear wrench?

 

Paitence
Snacks
Extra hand

 

10mm Rachey end wrench will makw the job 1000 times easier. Be sure to have one.

 

I bought a gear wrench and ended up not using it. I needed a sledge hammer to get the new Y into the I pipe. Extra Hands. Good Luck

 

How About the Correct headers. LOL.

I would of have them on by now but I was sent the best I can tell, one Ls-1 and a Right Truck one. I thought this only happens to other people. Later John

 

Ok, thanks guys! I hope to head out in a few minutes to a couple stores to pick up the tools im missing and grab some NGK TR55 spark plugs and then come back and get started

 

Time. The more time you allow for yourself, the happier you'll be. Took me a whole week to do my cam swap! I kept chipping away a little each day untill it was done, no need to rush, plenty of that once it gets running again.

 

Don't forget to get you a 02 socket. It will come in handy. Also a 10mm gear wrench or you will be cussing you car for hours. Also make sure you got a helper & plenty of beer.