help me decide!!!!!
Thread Starter
On The Tree
Joined: Jan 2007
Posts: 178
Likes: 0
help me decide!!!!! This is the problem i was going to get longtubes and ory next to add to the mods in my sig... i had picked hooker headers and their ory but im hearing that with longtubes and ory my car is going to be running extremely lean and i dont want to spend $550 on a tune because next i was going 2 save up for heads and cam and i know after that i def. need a tune..... another $550.... so i dont know if i should wait and do heads cam longtubes and ory all at once that way all i need is one tune... or is it going to be fine with longtubes and ory without tune?? if not i was thinking for the waiting time just put a ory to remove cats... help me decide thanks.
get the headers, and y pipe. The car should be fine without a tune. Tons of people run them without a tune, i am right now, with no problems. It will run better when you get a tune obviously so get one done when you can.
Chris
Chris
Thread Starter
On The Tree
Joined: Jan 2007
Posts: 178
Likes: 0
Originally Posted by GG01SS
I'm happy w/ my ORY, your 01 exhaust manifolds should be fine until you do the heads and cam. I have dynoed 340hp/350tq without LT.
Trending Topics
Thread Starter
On The Tree
Joined: Jan 2007
Posts: 178
Likes: 0
I understand now that i can get longtubes and ory now wihout a problem but i believe it wouldnt be smart to because im going to do heads/cam later on and in the process you have to take off the headers so i will get new longtubes then and install them in the process..... but for untill then i was thinking of a orp to take off stock cats? would it be worth it would i gain any hp? and im preety sure that if i get an orp for stock manifolds it wont fit the longtubes later will it? which one? i heard bassani has one for stock manifolds but its expensive and mufflex also for like 250 but thats to pricey and i dont think its worth it for that money depending on how much hp i would gain?? but then again i can probably take it to like mufflers for less and they can make a pipe to replace just the cats for cheap.... i was thinking of gutting them but want to keep them just incase.... also how would it sound catless with my borla catback?
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo How long are you planning on waiting to do heads and cam? If it was me I would go ahead and put the exhaust on there...the heads and cam swap would be enough work for me without having to worry about the exhaust at the same time. 
I have bassani ORY, bolts up to stock manifolds, w/ sims in rear O2 sensors. My cut out is in the stock 3" pipe just before it turns over the rear-usually spot. Make sure the dump is turned down enough so you have room to add electric cut out.
If you are getting heads and cam in the near future just save the cash and get LT and Y then, since the Bassani will not work w/ LT.
If you are getting heads and cam in the near future just save the cash and get LT and Y then, since the Bassani will not work w/ LT.
