After getting started a nearly 2 days later than I wanted, I began installing my PS LT's. So far, removal of components on drivers side has been uneventful, other than noticing that the Air tube gasket was nearly non-existent.
My question while I take a break is this. After all the posts I read, I completely forgot about that damn metal "block" that protrudes out. I was within mm of getting the header to go right up and poof! There was that little block "tab".

So.....grind it down? cut it off? best course of action would be??
I appreciat the help

 

grind it down, just enough to press the header through.

 

If it's getting in your way just grind it down. Some headers will clear it just fine, and some won't.

 

Grind it or get the car higher, everyone is different. Just a little more clearance and you might be able to work around it. Perfect example:

Did my PS LTs on my car when I first got them, had to cut the tab off. Did the SAME EXACT LTs (took 'em off my car and sold to a member, helped him put them on) on a 99 car. Tab was in the way. Jacked up a touch higher, wiggled around it, and they slid right up in. If you wanna cut, a sawzall makes very short work of it.

-J

 

Grinding, or getting it up higher helps. with my LT's I removed the oil filter and drain plug with great success.

 

I just chopped mine in half, took like 2 minutes.

 

grinded the **** out of mine, my car was a on a lift too so it was high enough...

 

cut like an 1/8 to a 1/4 off the tab it comes off really easy, why worry about grinding.

 

mine pacesetters fit in fine, esp. the passenger side. But do what these guys said! try and wrestle it up there without marking ur headers up too bad first tho..

 

my MAC's cleared the tab on the dr side but i had to wiggle around it. As for the passenger side......welll, lets not go there.

 

macs are really easy

 

ran into the same problem, went 2 clicks higher on the stands and it was np

 

get the car up higher and try again, if not then i would say grind it

 

I never had the "block problem" and I still dont know what it is lol. If its just a mm or so just grind it down.

 

Use whatever you got. If you don't have a sawzall, grind.

 

Got the little tab off - gotta love a sawzall. Header made it up in there after I cut that little S.O.B off. Is there a torque spec for PS LT's? The included instructions are really vague. Also, included was a "block off plate" for air and 3 gaskets. 2 same size, and 1 thats same size as that block off plate.? Any ideas on this??

 

11ft-lbs first pass, 18ft-lbs 2nd pass. You probably will NOT get a torque wrench on all the bolts. It is important to torque from the inside of the engine outward. Meaning, of the 6 bolts, torque the middle two first, and move outward, alternating each side. The block off plates? I don't quite understand what you're saying...

-J

 

Anybody?

 

With the Macs I just jacked up the motor.

 

Thanks, the page wouldnt refresh, disregard the immediate above post that says "anybody". Thanks for the reply lastcall190, I am gonna post up a few pics in about 5 mins better describing the other thing I'm talking about.