About to start my first cam swap. Have some questions
03-29-2013, 12:51 AM
#41
On The Tree
Join Date: May 2011
Location: Lake County Ca
Posts: 129
Likes: 0
Received 0 Likes
on
0 Posts
what else other than the crank issue? im just wondering because im going to be doing my first h/c swap soon
03-29-2013, 01:37 AM
#42
If the cam retainer plate gasket is flat and flush with the plate then replace it to get a good seal
check pushrod length, dont just go by what "other" people have done on similar combos..
those are some main ones I like to pay carefual attention to
03-29-2013, 01:00 PM
#43
On The Tree
Join Date: May 2011
Location: Lake County Ca
Posts: 129
Likes: 0
Received 0 Likes
on
0 Posts
If you changing the oil pump, dont pinch the O-ring when installing..
If the cam retainer plate gasket is flat and flush with the plate then replace it to get a good seal
check pushrod length, dont just go by what "other" people have done on similar combos..
those are some main ones I like to pay carefual attention to
If the cam retainer plate gasket is flat and flush with the plate then replace it to get a good seal
check pushrod length, dont just go by what "other" people have done on similar combos..
those are some main ones I like to pay carefual attention to
