Pics Of My Advanced Induction Dart/RHS 223cc Heads/Build Thread
#183
#1 Did you get it on the dyno and record the pulls?
#2 Jumping back to the milling topic and the ptv clearance?
Just my two cents and Martin briefly touched on it. The cam grind will dictate PTV clearance quite a bit.
#2 Jumping back to the milling topic and the ptv clearance?
Just my two cents and Martin briefly touched on it. The cam grind will dictate PTV clearance quite a bit.
#187
Thread Starter
TECH Senior Member
iTrader: (27)
Joined: Dec 2009
Posts: 9,728
Likes: 10
From: Jefferson City, MO
Just talked with Justin "Justune" last night and I'll be headed up to his dyno the week of October 14th through 18th. Most likely I'll go up there on Monday since I'm off work that day. He said to just give him a call a day before I want to roll up there. I'm very anxious to see what this combo ends up putting down. I'll update the thread once I have the results.
#189
Just talked with Justin "Justune" last night and I'll be headed up to his dyno the week of October 14th through 18th. Most likely I'll go up there on Monday since I'm off work that day. He said to just give him a call a day before I want to roll up there. I'm very anxious to see what this combo ends up putting down. I'll update the thread once I have the results.
#190
Thread Starter
TECH Senior Member
iTrader: (27)
Joined: Dec 2009
Posts: 9,728
Likes: 10
From: Jefferson City, MO
Not really. I tried getting in touch with a few places in St. Louis/St. Louis area, and none of them ever got back to me. Plus, I want to take it to Justin's dyno because he specializes in everything LSx and my buddy has used him to tune his cars and he has nothing but good things to say about him. I'd do it sooner, but I'm super busy this week and the following week with my 40 hr./week job and my side job.
#193
Thread Starter
TECH Senior Member
iTrader: (27)
Joined: Dec 2009
Posts: 9,728
Likes: 10
From: Jefferson City, MO
Local guys dyno is still broke, but our local car forum is trying to setup a big dyno day here soon if we can get enough participants. I guess they are going to rent a dyno for the day or something like that. If that falls through, then I'll just have to make time to get up to Kansas City and put it on Justune's dyno. Problem is it's 2 1/2 hours away and between my new job position and 3 kids, time isn't something I have a lot of.
#195
Thread Starter
TECH Senior Member
iTrader: (27)
Joined: Dec 2009
Posts: 9,728
Likes: 10
From: Jefferson City, MO
Well, through our local car forum, found a guy at the Lake of the Ozarks (about an hour from my house) that has a dynojet dyno, so I'm scheduled to go down there on Monday the 11th for 3 pulls.
#199
LS6