Straub Bushing Trunion Kits?
#821
I ordered some summit bushings and they had corrosion on the bushings so I sent them back. So I ordered some from chris and they came in THE EXACT BOX and had THE EXACT DIRECTION SHEET as the summit ones. The Straub trunnions did look smoother than the summit brand. and no corrosion
#823
TECH Junkie
I ordered some summit bushings and they had corrosion on the bushings so I sent them back. So I ordered some from chris and they came in THE EXACT BOX and had THE EXACT DIRECTION SHEET as the summit ones. The Straub trunnions did look smoother than the summit brand. and no corrosion
They are
#824
I got a kit directly from Straub and there was a lot of green corrosion on the ID of the bushings and rust on the shafts. Who actually manufactures these kits? Is it Smith Brothers?
#826
#828
Anyone ever see a failure of the Texas Speed rockers? https://www.texas-speed.com/p-6147-t...oller-tip.aspx
I have a set I was going to install, but if they use the same trunions as Comp and GM, I think I'd rather upgrade now than have issues down the road...
If so..
Would Straub or CHE kits work on my Texas Speed rockers?
I have a set I was going to install, but if they use the same trunions as Comp and GM, I think I'd rather upgrade now than have issues down the road...
If so..
Would Straub or CHE kits work on my Texas Speed rockers?
#829
Anyone ever see a failure of the Texas Speed rockers? https://www.texas-speed.com/p-6147-t...oller-tip.aspx
I have a set I was going to install, but if they use the same trunions as Comp and GM, I think I'd rather upgrade now than have issues down the road...
If so..
Would Straub or CHE kits work on my Texas Speed rockers?
I have a set I was going to install, but if they use the same trunions as Comp and GM, I think I'd rather upgrade now than have issues down the road...
If so..
Would Straub or CHE kits work on my Texas Speed rockers?
#830
TECH Senior Member
#831
TECH Enthusiast
iTrader: (14)
https://ls1tech.com/forums/parts-cla...cker-arms.html
https://ls1tech.com/forums/parts-cla...cker-arms.html
https://ls1tech.com/forums/parts-cla...cker-arms.html
Last edited by SSSTANG#1; 10-19-2017 at 09:30 PM.
#832
TECH Senior Member
#833
#838
#839
interesting that u says this... I have yet to hear any negative feedback on straub kits till now. I put 1k on my car this summer and that’s 1k of beating on it every chance i get. I drained 3 qts and found nothing in the oil. 10w30 mobil 1 synthetic and purolator filter.
#840
TECH Senior Member
The first oil change after trunnion bushing installation COULD show some bronze particles from the bushings wearing off any possible rough or sharp edges. It does not happen all the time, and nothing to worry about.