Cam Time Baby!!
Cam Time Baby!! Ok..I have a TR 230/236 592/603 111.5 on the way...as well as some Comp 7.400 pushrods. Still need to get some 918s,Chain,Gasket Set, and debating on lifters and rocker arms. Any advice? Guys think this cam ought to thump pretty good, and pull hard on a street driven cam only car? Mods in sig. Thanks.
For sale section I take it, I thought of buying that cam. It should thump decent but without headers is retaded IMO. It will choke it out, make it more of a dog down low and not produce even close to what it can.
I totally agree. I think I have a bad pushrod/rocker arm..so I am tearing into this 1st. Trust me...LTs and ORY are immediately following the cam.
i would do headers and exhaust first and then do the cam. and with the headers and sxhaust i would do some gears. 3.73 will work nice with that and that cam should put down some nice numbers as long as the above bolt ons are done otherwise you wont get much power out of it
TECH Senior Member
Joined: Mar 2004
Posts: 14,620
Likes: 17
From: BFE
No it wont chug along because of the 3600 stall. 3.23s will work fine for street, 3.73s for track use.
Make sure the 918s are installed at 1.80 height, I would use 7.425 Copm Cam p-rods
Of course headers are a must. Do it all topgether and tune immediately
Make sure the 918s are installed at 1.80 height, I would use 7.425 Copm Cam p-rods
Of course headers are a must. Do it all topgether and tune immediately
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo I like my 3.23s. I will go 3.73 when I get a 9" etc. But until this rearend pops...3.23s it is. Hell, I am only a car behind my brothers 3600Stall, LT/True Dual/3.73 car. Like Pred said....its not gonna chug with the 3600 in there, it just wont be as tight as it would with 3.73s. I agree on the Headers for sure tho. What do you guys think about rocker arms?..Any problems with using my stockers if they appear ok?
Last edited by LS1Silverado05; Oct 7, 2007 at 11:53 AM.