is my motor going out??
#1
TECH Regular
Thread Starter
iTrader: (2)
Join Date: Sep 2006
Location: RGV TX
Posts: 426
Likes: 0
Received 0 Likes
on
0 Posts
is my motor going out??
ok ive been getting this feeling like my motors ready to give out!! smoke comes out of the oil cap and it makes alot of noise and the oil pressure is at 20psi at idle i dont know if its just the unit or what but i definatly think somethings a miss!! what are the symptoms of a motor going bad?? P.S. its a 98 t/a w/92k mods in my sig
#2
TECH Resident
iTrader: (4)
mine was blowing white smoke under full throttle and It would puff black smoke on startup. Then it pooped out and made a shitload of nasty noise and my oil pressure was fluttering up and down. I broke the ringland on #7 and either a cause of the ringland or caused by the ringland the rod bearing spun on #7 as well.
Trending Topics
#9
10 Second Club
iTrader: (17)
Join Date: Oct 2005
Location: Tulsa, OK
Posts: 611
Likes: 0
Received 0 Likes
on
0 Posts
Pull your spark plugs and tell us what they look like.
Not all LS1's run forever, oil analysis (this isnt a magazine), and ya if you dont want to pull your plugs you need to take it to a shop. Take it to one or someone you can really trust. Half those shops love it when people walk in and think they need a new motor, thats big money for their pockets.
Pull your plugs tell us what they look like. If one is black and wet there's your prob.I'd try 7 first.
Not all LS1's run forever, oil analysis (this isnt a magazine), and ya if you dont want to pull your plugs you need to take it to a shop. Take it to one or someone you can really trust. Half those shops love it when people walk in and think they need a new motor, thats big money for their pockets.
Pull your plugs tell us what they look like. If one is black and wet there's your prob.I'd try 7 first.
#13
TECH Apprentice
Join Date: Sep 2005
Location: Amarillo, Tx
Posts: 340
Likes: 0
Received 0 Likes
on
0 Posts
I would change the oil pump (LS1's had a problem of oil pumps that just quit) and maybe look into the LS6 PCV conversion. Have you frequently been spinning up past 5000 rpm's?
check LS1howto.com for the PCV conversion, might... might be your problem.
check LS1howto.com for the PCV conversion, might... might be your problem.
#14
TECH Fanatic
iTrader: (18)
Join Date: Oct 2004
Location: Bay area, ca.
Posts: 1,205
Likes: 0
Received 0 Likes
on
0 Posts
Oil on the plugs and smoking out the cap is a good sign of blow by. Worn rings. 20 psi oil pressure also? Possible you have a problem with the sending unit, or possibly the gauge itself, but I doubt it in this situation. If you wanna check the pressure accuracy for sure, get a manual gauge and hook it up to where the oil sender goes.
How often do you check your oil?
My guess:
You developed a blowby problem due to washed rings which caused your car to start using oil. More then it did normally if you had a consumption problem to begin with. You forgot to check the oil, it got low and you spun some bearings which is whats causing your low oil pressure at idle.
Dont quote me on that, cause anything is possible. anyway, if this does happen to be the case, start looking into a rebuild.
If you're convinced this isnt the case, do a leakdown test to eliminate the rings being part of the problem and hook up a mechanical gauge to verify the oil pressure and go from there. Also, you can check to see if your car is smoking on acceleration or on deceleration. Smoking on accel indicates worn rings, smoke on decel can indicate you're getting oil seeping through your intake rocker bolts into the combustion chamber.
Good luck.
How often do you check your oil?
My guess:
You developed a blowby problem due to washed rings which caused your car to start using oil. More then it did normally if you had a consumption problem to begin with. You forgot to check the oil, it got low and you spun some bearings which is whats causing your low oil pressure at idle.
Dont quote me on that, cause anything is possible. anyway, if this does happen to be the case, start looking into a rebuild.
If you're convinced this isnt the case, do a leakdown test to eliminate the rings being part of the problem and hook up a mechanical gauge to verify the oil pressure and go from there. Also, you can check to see if your car is smoking on acceleration or on deceleration. Smoking on accel indicates worn rings, smoke on decel can indicate you're getting oil seeping through your intake rocker bolts into the combustion chamber.
Good luck.
#16
Registered User
Join Date: Dec 2007
Location: San Fernando
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
ok ive been getting this feeling like my motors ready to give out!! smoke comes out of the oil cap and it makes alot of noise and the oil pressure is at 20psi at idle i dont know if its just the unit or what but i definatly think somethings a miss!! what are the symptoms of a motor going bad?? P.S. its a 98 t/a w/92k mods in my sig