broken tail housing?

Reply Subscribe

Thread Tools

Search this Thread

Feb 7, 2008 | 10:35 PM

brokenbird

Thread Starter

TECH Apprentice

iTrader: (5)

Joined: Oct 2007

Posts: 393

Likes: 0

From: independence

broken tail housing?

i have a 98 trans am automatic car. and i keep breaking tail shaft housings. i could understand why if i was at the dragstrip all the time launching it but i havent been since september. the first time it broke i had the trans rebuilt. it broke shortly there after. so i bought a new one. ive broken it three times and its starting to get very expensive. does any have an idea of why this is happening?

Feb 7, 2008 | 11:27 PM

One Bad Z

11 Second Club

iTrader: (1)

Joined: Jun 2004

Posts: 655

Likes: 0

From: In a van down by the river, Missouri

get the driveshaft balanced & inspect the torque arm.

get a torque arm that doesnt mount to the tailshaft.

Feb 8, 2008 | 04:38 AM

john563

TECH Fanatic

iTrader: (17)

Joined: Sep 2006

Posts: 1,638

Likes: 0

From: dayton ohio

Quote:

Originally Posted by One Bad Z

get the driveshaft balanced & inspect the torque arm.

get a torque arm that doesnt mount to the tailshaft.

I did the ff too.First got the mount,then it happened again. i I got the driveshaft balanced and it happened on my new tranny plus it broke the tourque arm. I replace the tourque arm with a PST3 inch and replaced the driveshaft with a BMR and no problems. dont know if it was the tA flexing or if the balanve job on the drive shaft was broken,but this is what fixed it

Feb 8, 2008 | 06:17 AM

socmguy

Restricted User

iTrader: (18)

Joined: Apr 2007

Posts: 1,514

Likes: 0

From: Fayetteville, NC

buy an adjustable torque arm that mounts to the tunnel brace and not the tail shaft. A PST DS wouldn't hurt either!

Feb 8, 2008 | 07:57 AM

BMR Suspension

LS1Tech Premium Sponsor

iTrader: (6)

Joined: Jun 2004

Posts: 1,619

Likes: 0

Quote:

Originally Posted by brokenbird

Odds are the torque arm is the culprit. We sell a torque arm relocation kit that takes the strees of the torque arm off of the tailshaft of the transmission and moves it to a seperate mount. An additional advantage our relocation bracket offers is the ability to move the torque arm up and down in the car so you can fine tune the suspension more for your particular application. Here is a picture of the product

__________________

Allan Miller
President
BMR Suspension
www.bmrsuspension.com
(813) 986-9302

Feb 8, 2008 | 09:13 AM

s346k

TECH Junkie

iTrader: (4)

Joined: May 2005

Posts: 3,433

Likes: 1

From: johnson co.

what motor mounts?

trans mount?

Feb 8, 2008 | 12:00 PM

PREDATOR-Z

TECH Senior Member

Joined: Mar 2004

Posts: 14,620

Likes: 17

From: BFE

Change motor mounts and trans mount to poly urethane.
The stock trq arm is not as flimsy if geometry is right, I've ran flat 11s on stock arm without a hinch but suspension was full bushings and LCAs

Easiest way to cure is as BMR posted or with a Spohn TA