ok clear this up plz C/R issue
#1
*Bad Trader*
Thread Starter
Join Date: Nov 2001
Location: here and there
Posts: 1,459
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
if im not mistaken, 5.3 heads milled .015 gives right at 11.1-1 CR with 2.00/1.56 valves, im quite sure on this, but maaaaaaybe im wrong here......plz dont speculate, only if you 110% sure post, theres alot of misinfo going around on this topic....
![Huh](https://ls1tech.com/forums/images/smilies/LS1Tech/huh.gif)
#4
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
well....I KNOW a 60 cc chamber on a stock 5.7L shortblock (01 LS1) with the factory gasket makes 11.1:1 CR.....so...work from there....
#5
TECH Veteran
iTrader: (6)
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
well....I KNOW a 60 cc chamber on a stock 5.7L shortblock (01 LS1) with the factory gasket makes 11.1:1 CR.....so...work from there....
really.......hmmm....whats the thickness of a Felpro gasket vs. the stock (I think stock is 0.050" crushed right?) and where can I get one.....that might be a good little upgrade
![Grin](https://ls1tech.com/forums/images/smilies/LS1Tech/gr_grin.gif)
#6
![Default](https://ls1tech.com/forums/images/icons/icon1.gif)
well....I KNOW a 60 cc chamber on a stock 5.7L shortblock (01 LS1) with the factory gasket makes 11.1:1 CR.....so...work from there....
really.......hmmm....whats the thickness of a Felpro gasket vs. the stock (I think stock is 0.050" crushed right?) and where can I get one.....that might be a good little upgrade
![Grin](https://ls1tech.com/forums/images/smilies/LS1Tech/gr_grin.gif)