forrestd

I need these for an LS7 project but there isnt a dealer list on the Ferrea website. I need the S99100 or S99101 spring kit, shipped to Sydney (Australia). Can anyone help?

thanks!

forrestd

Perhaps a sponsor or someone could suggest a spring for about 690" lift (hydaulic setup)? Has anyone tried the livernois ones?

Jon@Texas-Speed

iTrader: (18)

We have some options for you very shortly. What time frame are you looking at?

forrestd

ASAP unfortunately - Currently looking at the ferrea or livernois springs. I've run the PRC 390CFM LS7 heads for a while but i think the valve springs have finally gone off. I road race the car and need these for the next round in 3 weeks.

88ls1blazer

iTrader: (1)

Livernois gets my vote. VERY nice springs, and know many LS7 cars with them doing quite well in road race events.

LivernoisMotorsports

iTrader: (1)

We have springs on the shelf, ready to ship. The springs themselves are $159.99 or the entire kit is $329.99 and includes:

Livernois Motorsports Chrome Dual Valve Springs (16)
Livernois Motorsports Titanium Retainers (16)
Livernois Motorsports ID Valve Spring Locators (16)
Super 7 Locks (32)
Rubber Valve Seals (16)

Thank you

Regards,

Rick LeBlanc
Livernois Motorsports

Jessica

Call up Ferrea directly and talk to them about it... they are not cheap springs but are the better choice in terms of quality of what you are talking about here.

Jes

forrestd

It's a bit difficult I am located in Australia. I was hoping a sponsor could sell me some. I will give it a go though.

koolrayz

iTrader: (26)

I had two Ferrea springs fail after 1200 miles. The long block was set up by LME so it wasnt an install issue and only a .635 lift cam. I posted about it and two others chimed in with simular issues. This was in 05 so im sure you could search my username and find the thread.

Ferrea =

forrestd

oh ok. Sorry to hear about the failure. Btw do PAC make Ferrea?