JR at Frankenstein is a gem
06-23-2020 | 11:31 PM
#43
TECH Addict
Joined: Sep 2010
Posts: 2,898
Likes: 467
Haha.
If you want a cam spec you need to list your engine mods.
I certainly want to make sure you not way off and that you have plenty of torque just below idle speed so it acts like launch control when you release the brakes.
Should gain you one tenth.
If you want a cam spec you need to list your engine mods.
I certainly want to make sure you not way off and that you have plenty of torque just below idle speed so it acts like launch control when you release the brakes.
Should gain you one tenth.
06-24-2020 | 06:23 AM
#46
11 Second Club
Joined: Jan 2003
Posts: 994
Likes: 120
Being a single plain, torques will begin at 11,000rpm.
strictly drag race only, for use with 6" 8000rpm torque converter
not for street usage!
single plains suck dog ***** .. everyone stick to the plastic intake and let big hammer go slow
true story!
strictly drag race only, for use with 6" 8000rpm torque converter
not for street usage!
single plains suck dog ***** .. everyone stick to the plastic intake and let big hammer go slow
true story!
at this point so stay tuned......
06-24-2020 | 09:23 PM
#52
Thread Starter
10 Second Club
Joined: May 2009
Posts: 3,427
Likes: 191
From: over dere
The following users liked this post:
slow4dr (06-25-2020)
The following 2 users liked this post by Bob570:
95sscamaro (10-11-2021), Corona (10-11-2021)