7.0PewterHawk

They just came in the other day picked them up for 200.00 a peice and that was bare.

LookinAtMyPlate

iTrader: (2)

Whens the install start

7.0PewterHawk

most likely not until June I just wanted to get them while they were cheap. Im sure the price of these heads are going to go up.

Hugger

iTrader: (21)

What size bore are you putting these on? What is the minimum bore that they will fit? I take it you are installing it with an LS7 intake. Have you decided on valves yet? They look great by the way. Can't wait to see them assembled and also your results with them.

7.0PewterHawk

From what Im told u gotta put these on a 4.000 bore or higher. Im going to either get a hardcore sheetmetal intake or get a more performance intake. Havent decided on valves yet and most likely I wont have them installed until june or maybe even later. So Im sure someone will have it done before me.

bigdog

i was wondering where did you get them from,for that price.

7.0PewterHawk

I got them right from GM a buddy of mine works there and he hooks me up.

SuperSporttruck

iTrader: (2)

7.0pewerhawk,

Do you have a part # for these heads, it would be much appreciated and do you happen to know what the intake manifold part # is for the L-92. thanks

gun5l1ng3r

So, who is offering an intake that will fit these heads?

Rock_Daddy

iTrader: (8)

Besides the stock truck manafold I'm not sure there are any other options at this time. I'd love to hear otherwise.

Hugger

iTrader: (21)

Will the LS7 intake not fit? I was under the impression that these heads were based off of the LS7 head design.

Ferocity02

iTrader: (60)

Those look VERY similar to the LS7 heads. Can anyone explain the differences?

Rock_Daddy

iTrader: (8)

They are kinda close but not close enough to use as Ive read. LS7 intakes won't work.

J-Rod

Look at the side by side pic posted by Joseph. The runer is actually taller, so you'd have to fill the floor probably. Also, you'd have to re-drill the bolt holes as the pattern is differnet. But, I think you could do it.

DesertFox

iTrader: (2)

I believe the LS7 heads are 12 deg heads, and these are 15 deg. Which might make the LS7 intake not able to work b/c of the angle. These heads are gonna be monsters for power production. I can't wait to see they put out. Good luck

Josh

J-Rod

The angle that you are referring to is the valve angle inside the head relative to the cylinder. The face of the heads are the same.

Wnts2Go10O

iTrader: (12)

has anyone thought of redrilling and tapping htese heads for the ls7 intake

Dune-LS1

Please post the part number.

7.0PewterHawk

GM Part # 12582714

SuperSporttruck

iTrader: (2)

Is there anyway to figure out the L-92 intake manifold part # ????