99t66ls1

Selling my custom sheetmetal intake, we used my car as a test car when designing and building this intake, worked great made great power, has opening for a 90 mm tb but i also have an adapter plate to run the stock throttle body. Car made numbers in my sig with this intake, 35 more horespower than it made with the stock ls1 intake.

Pics can be seen at

http://www.spectrum5racing.com/proje...sheetmetal.htm

Asking 1000$ with rails

DopeFedZ

iTrader: (34)

Any port/polish work on the inside of the intake?

99t66ls1

yes it is port matched to the weiland ls6 gaskets, and the insides are radiused in to the runners

99t66ls1

ttt pm me an offer if interested

nitrorocket

iTrader: (12)

p.m. sent.

juiced_z28

iTrader: (12)

Gotta repect fabrication way beyond bolt up. Props to you sir. TTT

99t66ls1

Pms all returned would also consider trade on 6.0 cylinder heads. Partial trade or maybe full trade and cash on a good ported set.

ThePizzaGTP

Agreed. I was sittin here thinkin "holy isht."

427 LS1

iTrader: (10)

I have a set of 6.0L stock heads and also a nice set of Stage 2 ported 98 LS1 heads, they flow 305 CFM and have really nice 1.550 springs good for huge lift. 2.055 intake and 1.60 exhaust. Let me know if you are interested. Thanks Dave

renegademike928

what a nice piece, is it the same length as stock? or shorter?

99t66ls1

Yes i would be interested in the stock 6.0 heads if im going to do heads i want to lower compression so the ported ls1's do me no good. Pm and we'll talk about prices. No the intake is taller than stock but the runners are quite a bit shorter than stock.

Runwhatchabrung

iTrader: (2)

do you have the actual measurements hieght, width etc. Im interested but the measurements are crucial for the setup im doing. thanks.

427 LS1

iTrader: (10)

This has been sold to me. Thanks Dave