FS: Camaro Custom 12" Sub Box/Kicker 12" CVX/2 Kicker Amps
08-08-2007, 08:42 PM
#1
TECH Resident
Thread Starter
iTrader: (6)
Join Date: Oct 2004
Location: Palestine (East Texas), Texas
Posts: 777
Likes: 0
Received 0 Likes
on
0 Posts
FS: Camaro Custom 12" Sub Box/Kicker 12" CVX/2 Kicker Amps Ok... time for a tune, and my ears hurt enough as it is. So I'm giving up the system.
Price Drop : $500 + actual shipping costs
This is a system that I built myself. The box is a small sealed enclosure that houses 1 12" Subwoofer. It will accommodate up to a 6 3/4" deep sub. It is carpeted on the face (the only visible part when installed) and sits in the small spot on the drivers side next to the t-top storage.
http://memimage.cardomain.net/member.../2171541_6.jpg
http://memimage.cardomain.net/member.../2171541_7.jpg
The subwoofer is a Kicker Comp VX (CVX124). 12", dual 4 ohm voice coils, 750w RMS, 1500w peak. It still has a free replacement warranty from Fry's Electronics. It is basically a round version of the Kicker L7, same magnet, etc., etc., etc.
http://www.cardomain.com/item/KIC06CVX124
Both of the amps are about 1 1/2 years old, and I have never had any problems with them.
The first of the two amps is a Kicker ZX400.1. It is a one channel Class D sub amp, with remote bass control. The certificate in the original box (I still have the certificate) rates this amp at 470w RMS, however, the product listings rate it at 400w RMS.
http://www.cardomain.com/item/KIC06ZX4001
The second of the two amps is a Kicker ZX200.4. This is a 4 channel that has been used to power my door panel speakers, and the ones next to the rear seats. It is 50w RMS x 4 when run at 2 Ohms (with any 2 ohm 6.5" speaker), or 35w RMS x 4 when run at 4 ohms. It can also be bridged to a 2 channel for more power.
http://www.cardomain.com/item/KIC06ZX2004
Here are pics of the two amps mounted together on my amp rack, which I will include. Just a piece of plywood with a few holes in it for wiring, but it makes a nice amp rack for an fbody.
http://www.cardomain.com/member_page...541_8_full.jpg
None of this is stolen. It was all either made by me, or bought at Fry's Electronics. I will include whatever wiring I pull out, however I will warn that some of the AV's were almost too short for this application. If it is shipped, I will charge the buyer exactly what I pay for packaging and shipping. I'm not the one to rip someone on shipping.
This, along with a couple pairs of speakers, is the ultimate solution to Monsoon problems. The system is still functioning in my Camaro, and if someone needs it, I could get DB levels as it sits. I will say I was glad I didn't buy the 750 watt amp. This was as much bass as I'd ever want, that rear glass makes a big difference.
Price Drop : $500 + actual shipping costs
Price Drop : $500 + actual shipping costs
This is a system that I built myself. The box is a small sealed enclosure that houses 1 12" Subwoofer. It will accommodate up to a 6 3/4" deep sub. It is carpeted on the face (the only visible part when installed) and sits in the small spot on the drivers side next to the t-top storage.
http://memimage.cardomain.net/member.../2171541_6.jpg
http://memimage.cardomain.net/member.../2171541_7.jpg
The subwoofer is a Kicker Comp VX (CVX124). 12", dual 4 ohm voice coils, 750w RMS, 1500w peak. It still has a free replacement warranty from Fry's Electronics. It is basically a round version of the Kicker L7, same magnet, etc., etc., etc.
http://www.cardomain.com/item/KIC06CVX124
Both of the amps are about 1 1/2 years old, and I have never had any problems with them.
The first of the two amps is a Kicker ZX400.1. It is a one channel Class D sub amp, with remote bass control. The certificate in the original box (I still have the certificate) rates this amp at 470w RMS, however, the product listings rate it at 400w RMS.
http://www.cardomain.com/item/KIC06ZX4001
The second of the two amps is a Kicker ZX200.4. This is a 4 channel that has been used to power my door panel speakers, and the ones next to the rear seats. It is 50w RMS x 4 when run at 2 Ohms (with any 2 ohm 6.5" speaker), or 35w RMS x 4 when run at 4 ohms. It can also be bridged to a 2 channel for more power.
http://www.cardomain.com/item/KIC06ZX2004
Here are pics of the two amps mounted together on my amp rack, which I will include. Just a piece of plywood with a few holes in it for wiring, but it makes a nice amp rack for an fbody.
http://www.cardomain.com/member_page...541_8_full.jpg
None of this is stolen. It was all either made by me, or bought at Fry's Electronics. I will include whatever wiring I pull out, however I will warn that some of the AV's were almost too short for this application. If it is shipped, I will charge the buyer exactly what I pay for packaging and shipping. I'm not the one to rip someone on shipping.
This, along with a couple pairs of speakers, is the ultimate solution to Monsoon problems. The system is still functioning in my Camaro, and if someone needs it, I could get DB levels as it sits. I will say I was glad I didn't buy the 750 watt amp. This was as much bass as I'd ever want, that rear glass makes a big difference.
Price Drop : $500 + actual shipping costs
Last edited by jmdale1984; 08-14-2007 at 11:05 PM. Reason: price change
