FS 6.0 LQ9 long block with Victor jr....
#1
Launching!
Thread Starter
iTrader: (37)
Join Date: Nov 2007
Location: Finger TN.
Posts: 280
Likes: 0
Received 0 Likes
on
0 Posts
FS 6.0 LQ9 long block with Victor jr....
Ok guys I have a 6.0 lq9 flatop motor stock rods, crank, and pistons but ARP rod bolts, main studs, and balance bolt it is an iron block, the cam is a 212/224 580ish lift on a 114.5 ls. The heads are 317 castings with a comp cams 600 lift springs and tit. retainers it also has comp molly pushrods and ARP head bolts. As far as acc. it has a Victor jr carb intake, water pump, ballancer, flywheel, and all covers fc, rc, op, and vc's. Also 8 truck coils and brackets. All you would need for a carb setup is a carb , starter, and an MSD. This motor has WAY less than 5k miles and has seen some n20 but the tune has ALWAYS been perfect. It is still in vehicle if you are close enough and would like to hear it run...$3000.00... I will take $225 less without the intake or will sell without some or with extra parts just let me know what you do/dont want.....thanks, Heath...
Reason for selling is i want to go to a stroker and the motor runs too good to tear it apart. I AM OPEN TO TRADES! LOOKIN FOR AFTERMARKET HEADS OR 402+ STROKER PARTS!!! THANKS
Reason for selling is i want to go to a stroker and the motor runs too good to tear it apart. I AM OPEN TO TRADES! LOOKIN FOR AFTERMARKET HEADS OR 402+ STROKER PARTS!!! THANKS
Trending Topics
#9
Launching!
Thread Starter
iTrader: (37)
Join Date: Nov 2007
Location: Finger TN.
Posts: 280
Likes: 0
Received 0 Likes
on
0 Posts
Well it usally has my location on there when i post west TN is where im at...
The motor has been 6.20s and consistant 30s, as far as dyno #s its never been on one but i would "guess" about 480 on the motor and that is only a guess!!! on just motor with a n2o conv and 4.10 gear it runs 7.20s @ 3380#...
Stangaddict
ls1 foumula01
You both have PMs...
And ill be keeping the intake if it doesnt sell with the complete motor. thanks Heath
The motor has been 6.20s and consistant 30s, as far as dyno #s its never been on one but i would "guess" about 480 on the motor and that is only a guess!!! on just motor with a n2o conv and 4.10 gear it runs 7.20s @ 3380#...
Stangaddict
ls1 foumula01
You both have PMs...
And ill be keeping the intake if it doesnt sell with the complete motor. thanks Heath
#11
TECH Enthusiast
iTrader: (1)
Join Date: Jul 2003
Location: Central AR
Posts: 521
Likes: 0
Received 0 Likes
on
0 Posts
Not a bad deal for a turnkey setup. GL selling! Maybe we can meet up at Memphis in the spring at one of the drag radial races, although the drag radial stuff around here is so tough with Mills, Kolivas, Bridge, etc so "local".