99blancoSS

iTrader: (115)

All Pro raced prepped (ported) heads, drilled for offset rockers. New titanium intake valves, slightly use stainless exhaust valves. Flow sheets on the way, they flow 355 at .600 on the intake and 240-260 on the exhaust.













$2700 shipped to your door.

theblur98ss

iTrader: (71)

what size chambers? Are these assembled heads? If so what springs and lift?

99blancoSS

iTrader: (115)

no springs, 72cc chambers, flow sheets are on the way so I dont have a lot of info on them other than whats posted. I tried to get a pic of the exh port but my camera wouldnt focus down in. Its real nice. They flow from what I was told 240 at 600 and 260 at .7 or .800 on the exh

99blancoSS

iTrader: (115)

friday is a good day to buy heads, I will accept reasonable offers.

99blancoSS

iTrader: (115)

bump bump

aNuBiS

iTrader: (25)

Retarded set of heads my friend. What size runners. Seems like a pretty good deal for someone looking to go all out on a big cubes motor.

99blancoSS

iTrader: (115)

time for a bump

99blancoSS

iTrader: (115)

247 on the runner

silverbeast

iTrader: (16)

we need a price. also why has it been drilled for off set rockers? I have a set of Jesel SS rocker arms on my car.... will these work? thanks

99blancoSS

iTrader: (115)

The price is listed under the pictures $2700 shipped, I will accept offers. They were race prepped, offset rockers are part of that. Hi rpm top ends need the rigidity an offset pattern provides. They were set up for Jesels, I dont think yours are correct.

Solid346

what is the valve size that goes on it? also does the spring pockets accept 1.46 to 1.55 spring with no modification?
(offset rockers) do you mean it will accept stock rockers or T&D

99blancoSS

iTrader: (115)

2.12 , 1.60, I'll go measure the pocket and post back, Was set up for Jesel's, I think the T+D will work as well. I measure 1.504

Solid346

wow, these valves are too big for my 346ci...

but i will say good price for the heads, good luck on selling these beauties

99blancoSS

iTrader: (115)

thank you

99blancoSS

iTrader: (115)

Killer heads here

RAMPANT

iTrader: (17)

What size chamber are these?

99blancoSS

iTrader: (115)

72cc is what I was told, I dont have equiptment to pour them to verify.

RAMPANT

iTrader: (17)

Too bad, I might be looking for heads, but thats to big since my short is done already and I need between 63-66. Not sure how much would need to be milled to get there.

What angle are these, the 12 degree or the 15?

To the top for nice heads.

99blancoSS

iTrader: (115)

15*, milling doesnt cost that much, some will do it for $75, I can have them milled to the chamber you want, we'll work it out if your serious about buying them.

99blancoSS

iTrader: (115)

bump bump