Incon Twin Turbo Kit For Sale
#1
Incon Twin Turbo Kit For Sale
I purchased this a few weeks ago w/o thinking it over like an idiot. I dont see a point to mod a car anymore than it currently is when I dont even drive it. The kit is pretty much complete. It is only missing the pipes coming from the y-pipe merge to the turbo downpipes but any y-pipe can be made to fit. Here is a basic rundown:
2 gt2871r garret turbos, dual ball bearing,liquid cooled
2 cast manifolds
numerous silicone tubing for cold side
y pipe merge
butt pipe
2 intercoolers
2 filters
full instructions
oil pump
will also include the correct drill bit and tap for the pan.
steel braided lines
rubber lines
lots and lots of fittings.
check valves
All hot parts are ceramic coated as you can see from the pics. This was onfires kit which he sold last yr and to my knowledge has not been installed since. He ran 9.9 at 141 with this exact kit on a stock cube motor. Turbos are in perfect condition. No shaft play and spin very freely. I am not new to turbos as you can see by my sig. It also includes a Greddy type S BOV welded to a polished MAF pipe. It is setup to run speed density but that can easily be changed to run the stock MAF. It has a Tilton scavenge pump as well. This kit retains AC and DOES NOT require an aftermarket K-member.
I will post pics of the Butt pipe (intake charge pipe) after it is done being painted tomorrow. It will be Anodized red.
I pd 4200 for it a few weeks ago. Will sell for 3600 and that is firm and no trades whatsoever!!!!! I dont have to sell it and if it sits long enough I might install it. Right now it is just not a priority so if someone wants it cool. here are some pics. Duct tape on the intercooler piping is to prevent chaffing which anyone who knows the Incon kit will tell you is normal.
2 gt2871r garret turbos, dual ball bearing,liquid cooled
2 cast manifolds
numerous silicone tubing for cold side
y pipe merge
butt pipe
2 intercoolers
2 filters
full instructions
oil pump
will also include the correct drill bit and tap for the pan.
steel braided lines
rubber lines
lots and lots of fittings.
check valves
All hot parts are ceramic coated as you can see from the pics. This was onfires kit which he sold last yr and to my knowledge has not been installed since. He ran 9.9 at 141 with this exact kit on a stock cube motor. Turbos are in perfect condition. No shaft play and spin very freely. I am not new to turbos as you can see by my sig. It also includes a Greddy type S BOV welded to a polished MAF pipe. It is setup to run speed density but that can easily be changed to run the stock MAF. It has a Tilton scavenge pump as well. This kit retains AC and DOES NOT require an aftermarket K-member.
I will post pics of the Butt pipe (intake charge pipe) after it is done being painted tomorrow. It will be Anodized red.
I pd 4200 for it a few weeks ago. Will sell for 3600 and that is firm and no trades whatsoever!!!!! I dont have to sell it and if it sits long enough I might install it. Right now it is just not a priority so if someone wants it cool. here are some pics. Duct tape on the intercooler piping is to prevent chaffing which anyone who knows the Incon kit will tell you is normal.
Last edited by big reg; 08-11-2008 at 05:38 AM.
Trending Topics
#20
I'm trying to find a way to get a couple grand.. then I'll be biting the bullet and going with some form of FI. Basically, whoever's kit is still for sell when I have the money will probably be the one.. lol.. If I get the funds I'll hit you up if it's still for sale..