Low compression Pistons+Rods
#2
TECH Junkie
iTrader: (31)
this is what i would use these parts for the money
http://www.jegs.com/i/Sealed+Power/8...41F30/10002/-1
http://www.jegs.com/i/Scat/942/6570021/10002/-1
http://www.jegs.com/i/Sealed+Power/8...41F30/10002/-1
http://www.jegs.com/i/Scat/942/6570021/10002/-1
#6
12 Second Club
iTrader: (11)
Well the 2 I mentioned are good choices, I'd probably get CPs, I wish I had but it's to late I got JEs with a -31cc dish. My CC chambers are prety big and my compression comes out to around 8.5:1 I did skimp on the rods and got generic brand 4340 H beams. I have a eagle 4340 crank. If I were to do it again I would have got the same crank but eagle or scat rods and CP pistons. But my engine is allready built!
#7
TECH Apprentice
Thread Starter
iTrader: (6)
Join Date: Apr 2007
Posts: 338
Likes: 0
Received 0 Likes
on
0 Posts
Well the 2 I mentioned are good choices, I'd probably get CPs, I wish I had but it's to late I got JEs with a -31cc dish. My CC chambers are prety big and my compression comes out to around 8.5:1 I did skimp on the rods and got generic brand 4340 H beams. I have a eagle 4340 crank. If I were to do it again I would have got the same crank but eagle or scat rods and CP pistons. But my engine is allready built!
can you provide me with part numbers?
Thanx