388 dyno results...
#1
388 dyno results...
First off, this setup is nowhere near optimized. Cam spec'd for a single plane and 250 shot. Also had a little miscommunication with Bret Bauer about where I should've installed my valvesprings, so the power fell off (valve float) at only 5600 rpm.
Specs:
388ci
12.5 scr
Ported AFR 210s, 320cfm at .600
Ported LT4 intake
Bauer HR Cam 24x/25x .620ish 107lsa
58mm TB
Pacesetter LTs w/ 3" Y
4" single with 2 vibrant bullets and 1 hooker maxflo
Stock 6sp, mcleod bell, spec stage V clutch
PST ds
Moser 9" w/ 4.11s
Numbers....
439rwhp at 5600 rpm
450rwtq 4400-4800 rpm
400 rwtq at only 2800 rpm
I don't have a graph sorry guys, gonna swap valvesprings tomorrow morning and hit the local 1/8 mile in the evening. Then redyno tune the beast in the next week or two with a 150 shot. Oh btw, the new MSD 6AL-2 Programmable box was worth 2 ft lbs and .4 hp over a stock setup.
Specs:
388ci
12.5 scr
Ported AFR 210s, 320cfm at .600
Ported LT4 intake
Bauer HR Cam 24x/25x .620ish 107lsa
58mm TB
Pacesetter LTs w/ 3" Y
4" single with 2 vibrant bullets and 1 hooker maxflo
Stock 6sp, mcleod bell, spec stage V clutch
PST ds
Moser 9" w/ 4.11s
Numbers....
439rwhp at 5600 rpm
450rwtq 4400-4800 rpm
400 rwtq at only 2800 rpm
I don't have a graph sorry guys, gonna swap valvesprings tomorrow morning and hit the local 1/8 mile in the evening. Then redyno tune the beast in the next week or two with a 150 shot. Oh btw, the new MSD 6AL-2 Programmable box was worth 2 ft lbs and .4 hp over a stock setup.
#5
LOL ah the newb talk, sorry man i've been here for a while just don't care to post much cause i can't stand some of the stuff that gets talked on here, and the reason i asked if it was on motor was because 1) he never said and 2) i've seen some prett bad under powered stroked LT's.. Sorry for the thread hi-jack but i guess i'm a "newb" lol