Just bored, cruise n around burning tires off... listen to that rear end about to pop.

I made a ghetto helmet cam so bare with me lol.

http://www.youtube.com/watch?v=6S2lN3P6I9k

Mods.. way too many to list, stock 350.. tuned, spec stage 3 clutch, 4.10 gears, long tubes, slp loudmouth exhaust, no cats... full suspension... :0) etc.. etc.. etc...

 

sounds good!

 

nice vid! Your car moving out pretty good!

 

sounds sick!

 

sweet sounding car man

 

Makes me absolutely ache to drive mine! Sounds great, My heads and cam make the LM1 obnoxious. Yours sounds excellent.

 

squeaky bushings are GAYYYYYYYYYYYy lmao i really really miss my old 383

 

i like the video man nice car sounds good

 

Thanks guys, I cant wait to put a 383 in this car, thats kinda why i did this video.. before it goes under the knife. And did anyone notice how bad that old 10 bolt hums? lol its getting close to death!

 

HAHAHA that thing is crying man get her taken care of. coming from someone who has done a 383 swap you will notice a night and day difference. i couldnt believe the difference in mine and mine was a very small build literally just a 383 with a LT4 hotcam thats pretty much it. youll be quite satisfied but really makes me miss mine lol

 

Sounds like a typical after market ring and pinion 10 bolt to me lol. Then again if you can hear it in the video, I can only imagine how bad that thing howls irl.

 

What are all those wires hanging?

 

Sounds nice. Do you really need that aftermarket Tac on your pillar for a bolt-on car?

Also for a stage 3 clutch, a few times there it sounded like it was either slipping bad or you were letting it out waaaaay too slow.

 

hmm, possibly, but it spins out the *** man. And do not be hating on my 5 inch waste of money tac. I like it, but there is alot in store for this car, so it all builds up to the final project. :

 

But, point is well noted... its possible. Clutch only has about 3k on it. I dont usually rip on it much, but since its going under the knife i dont care