New Golan 383
12-17-2009, 03:39 PM
#7
Staging Lane
Thread Starter
iTrader: (2)
Join Date: Jul 2009
Location: Lino Lakes, MN
Posts: 70
Likes: 0
Received 0 Likes
on
0 Posts
The motor is built to handle some boost, I was thinking of a D1SC @ about 8 lbs.
I am going to go from the bottom, this is my first time. They broke it in on the dyno, it pulled 467 fwhp @ 5800 and 455 tq @ 5100. I am thinking about having a local shop chassis dyno it.
Yea it was good, my wife didn't even get mad when I asked if I could buy it.
Trending Topics
12-17-2009, 07:34 PM
#17
Staging Lane
Thread Starter
iTrader: (2)
Join Date: Jul 2009
Location: Lino Lakes, MN
Posts: 70
Likes: 0
Received 0 Likes
on
0 Posts
Thank you
Hey Z-RATED94 nice looking car, what size are those rear tires?
I have been having a hard time with putting a different engine in that this car because it is so clean but have come to the conclusion that i will probably never sell it anyway. I figure at 51 now when I'm feeling to old to drive it one of the grandson's will be ready for it.
Thanks
Brad
Hey Z-RATED94 nice looking car, what size are those rear tires?
I have been having a hard time with putting a different engine in that this car because it is so clean but have come to the conclusion that i will probably never sell it anyway. I figure at 51 now when I'm feeling to old to drive it one of the grandson's will be ready for it.
Thanks
Brad
12-17-2009, 07:47 PM
#18
TECH Fanatic
iTrader: (6)
Join Date: Nov 2007
Location: Carol Stream Il.
Posts: 1,523
Likes: 0
Received 0 Likes
on
0 Posts
Brad, the tires for some reason look a little bigger than they should in the picture. Their MT drag radials, 275/50/15. The car inself has 32k on it, and I have a few years on you too. Good to see another older gearhead on LS1TECH.
What compression ratio are you at that you might put a D1SC on it?
What compression ratio are you at that you might put a D1SC on it?
to bad i wish he could