LS1TECH - Camaro and Firebird Forum Discussion

LT1-LT4 Modifications 1993-97 Gen II Small Block V8

full wire tuck from engine bay

Thread Tools
 
Search this Thread
 
Old Nov 3, 2012 | 02:14 AM
Share
  #1  
94whiteZ's Avatar
94whiteZ
Thread Starter
Staging Lane
 
Joined: Jun 2012
Posts: 75
Likes: 0
From: sac
Default full wire tuck from engine bay
if i did it right a few pics of complete wire tuck and heater delete until i put aftermarket one in.
Attached Thumbnails full wire tuck from engine bay-maro1.jpg   full wire tuck from engine bay-maro2.jpg   full wire tuck from engine bay-maro3.jpg   full wire tuck from engine bay-maro4.jpg   full wire tuck from engine bay-maro5.jpg  

Reply
0
Old Nov 4, 2012 | 08:25 AM
Share
  #2  
krzy_z's Avatar
krzy_z
On The Tree
15 Year Member
iTrader: (1)
 
Joined: Feb 2010
Posts: 164
Likes: 0
From: winnipeg, mb, canada
Default
where U planning to mount ur underhood fuse block, isnt wiring so much fun.
Reply
0
Old Nov 4, 2012 | 02:30 PM
Share
  #3  
94whiteZ's Avatar
94whiteZ
Thread Starter
Staging Lane
 
Joined: Jun 2012
Posts: 75
Likes: 0
From: sac
Default
Tons of fun lol thinking in glove box since only insurance and reg goes in it. And be out of sight. Were do u plan on putting urs?
Reply
0
Old Nov 4, 2012 | 03:42 PM
Share
  #4  
krzy_z's Avatar
krzy_z
On The Tree
15 Year Member
iTrader: (1)
 
Joined: Feb 2010
Posts: 164
Likes: 0
From: winnipeg, mb, canada
Default
Im not too sure yet it all depends if i keep the stock nox or run a new box to clean up some of the unwanted things i. The car but i was thinking behind the glove box where i can get to it from the underside but i still need to put the dash in place first to see where is good.
Reply
0
Old Nov 4, 2012 | 08:31 PM
Share
  #5  
94whiteZ's Avatar
94whiteZ
Thread Starter
Staging Lane
 
Joined: Jun 2012
Posts: 75
Likes: 0
From: sac
Default
I got all the wire to the fuse box on the inside bolted u under dash. It was a bitch to get it to fit between the pedal assembly and the metal above it.. I cut some metal out and tucked it up. U should cut out as much wiring as possible so u dnt run into that problem I just don't know wiring like you.
Reply
0
Old Nov 4, 2012 | 10:33 PM
Share
  #6  
TwoFast4Lv's Avatar
TwoFast4Lv
10 Second Club
20 Year Member
Photogenic
iTrader: (8)
 
Joined: Nov 2001
Posts: 10,023
Likes: 6
From: LT1 land...the "409" of the 90s!
Default
Why the huge hole?

Here is my front wiring

Reply
0
Old Nov 5, 2012 | 10:06 AM
Share
  #7  
krzy_z's Avatar
krzy_z
On The Tree
15 Year Member
iTrader: (1)
 
Joined: Feb 2010
Posts: 164
Likes: 0
From: winnipeg, mb, canada
Default
Originally Posted by TwoFast4Lv
Why the huge hole?

Here is my front wiring

Thats how i plan to run my front wiring
Reply
0

Trending Topics

Old Nov 5, 2012 | 10:54 AM
Share
  #8  
94whiteZ's Avatar
94whiteZ
Thread Starter
Staging Lane
 
Joined: Jun 2012
Posts: 75
Likes: 0
From: sac
Default
Looks hella clean hole isn't as big as u think but it's already sealed up. How did u get the fuse box in the car with out cutting wires?
Reply
0
LS1 Tech Stories

The Best V8 Stories One Small Block at Time

story-0

6 Gifts Neither Your Dad Nor Grad Will Shove Into the 'Trinket Drawer'

 Brett Foote
story-1

Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?

 Pouria Savadkouei
story-2

Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine

 Verdad Gallardo
story-3

7 Most Reliable High-Performance Engines GM Has Ever Built

 Verdad Gallardo
story-4

Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin

 Verdad Gallardo
story-5

6 Common C5 Corvette Failures and What's Involved In Repairing Them

 Pouria Savadkouei
story-6

Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph

 Verdad Gallardo
story-7

Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked

 Pouria Savadkouei
story-8

Top 10 Most Powerful Chevy Trucks Ever Made!

 
story-9

Hennessey's New Supercharged Silverado ZR2 Has 700 HP

 Verdad Gallardo
Old Nov 5, 2012 | 12:03 PM
Share
  #9  
krzy_z's Avatar
krzy_z
On The Tree
15 Year Member
iTrader: (1)
 
Joined: Feb 2010
Posts: 164
Likes: 0
From: winnipeg, mb, canada
Default
I just disconnected all the connectors from inside the car and pulled them threw the engine bay
Reply
0
Old Nov 5, 2012 | 01:04 PM
Share
  #10  
94whiteZ's Avatar
94whiteZ
Thread Starter
Staging Lane
 
Joined: Jun 2012
Posts: 75
Likes: 0
From: sac
Default
See how much I hate wiring. I didn't even think of that that's like a slap in the face I should of thought of it. I think I didn't cause I only started doing the wire tuck cause blew tranny and got it back sooner than I thought im ready to drive it see how thus level 2 trans is.
Reply
0
Old Nov 5, 2012 | 02:59 PM
Share
  #11  
krzy_z's Avatar
krzy_z
On The Tree
15 Year Member
iTrader: (1)
 
Joined: Feb 2010
Posts: 164
Likes: 0
From: winnipeg, mb, canada
Default
Well its one way to fill the whole in any ways cause nothing wont go there any more where u running ur engine harness?
Reply
0
Old Nov 5, 2012 | 03:22 PM
Share
  #12  
94whiteZ's Avatar
94whiteZ
Thread Starter
Staging Lane
 
Joined: Jun 2012
Posts: 75
Likes: 0
From: sac
Default
Tuck the wires that have to be on motor better and vette covers then the other wires in my inner fender and under dash. Unless u have a better way that i haven't figured out lol
Reply
0
Old Nov 5, 2012 | 08:02 PM
Share
  #13  
TwoFast4Lv's Avatar
TwoFast4Lv
10 Second Club
20 Year Member
Photogenic
iTrader: (8)
 
Joined: Nov 2001
Posts: 10,023
Likes: 6
From: LT1 land...the "409" of the 90s!
Default
Originally Posted by krzy_z
i just disconnected all the connectors from inside the car and pulled them threw the engine bay
x2!
Reply
0
Old Nov 6, 2012 | 11:34 AM
Share
  #14  
krzy_z's Avatar
krzy_z
On The Tree
15 Year Member
iTrader: (1)
 
Joined: Feb 2010
Posts: 164
Likes: 0
From: winnipeg, mb, canada
Default
my engine harness I depinned and ran all the wires to the back of the motor and extened the wires so I can mount the pcm inside the car which will go thru the fire right behind the motor to hide all the wiring, Im hopping the injector wires I had loom up will look ok. I havnt put my harness on the engine yet after it was finished.
Reply
0
Old Nov 6, 2012 | 12:44 PM
Share
  #15  
94whiteZ's Avatar
94whiteZ
Thread Starter
Staging Lane
 
Joined: Jun 2012
Posts: 75
Likes: 0
From: sac
Default
Can I see a pic cause I was planning on computer in car as well I think there is enough slack without extending those wires if I remember correctly
Reply
0
Old Nov 6, 2012 | 05:19 PM
Share
  #16  
krzy_z's Avatar
krzy_z
On The Tree
15 Year Member
iTrader: (1)
 
Joined: Feb 2010
Posts: 164
Likes: 0
From: winnipeg, mb, canada
Default
The plan is to put the harness on the motor this weekend and install the motor so ill have some pics for the install once its done, i hope i can get it done this weekend cause a big snow fall is heading our way and i dont want my car to be stuck in my yard lol
Reply
0
Tags
Back to Subforum
LT1-LT4 Modifications
View Next Unread
Hoses from water pump




Advanced Search

All times are GMT -5. The time now is 04:37 PM.

story-0
6 Gifts Neither Your Dad Nor Grad Will Shove Into the 'Trinket Drawer'

Don't get dad new socks or a grill brush this year.

By Brett Foote | 2026-06-04 18:13:20


VIEW MORE
story-1
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?

Slideshow: We take a close look at the ONE and Artidiag 800BT2 diagnostic tools from Topdon and the reasons to buy one over the other.

By Pouria Savadkouei | 2026-05-28 11:05:11


VIEW MORE
story-2
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine

Slideshow: The controversial Ferrari F6 swaps its original flat-12 for a Corvette Z06-derived LT4 V8 and sends power to four rear wheels through a custom-built drivetrain.

By Verdad Gallardo | 2026-05-26 18:23:54


VIEW MORE
story-3
7 Most Reliable High-Performance Engines GM Has Ever Built

Slideshow:These GM engines didn't just make huge power, they survived abuse, boost, track days, and six-digit mileage with a reputation for refusing to quit.

By Verdad Gallardo | 2026-05-21 16:45:27


VIEW MORE
story-4
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin

Slideshow: This heavily modified 1971 Camaro mixes classic muscle car styling with a fifth-generation Camaro interior and modern LS3 power.

By Verdad Gallardo | 2026-05-12 18:06:42


VIEW MORE
story-5
6 Common C5 Corvette Failures and What's Involved In Repairing Them

Slideshow: From wobbling harmonic balancers to failed EBCMs, these are the issues that define long-term C5 ownership and what repairs typically involve.

By Pouria Savadkouei | 2026-05-07 18:44:57


VIEW MORE
story-6
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph

Slideshow: A modern Camaro transformed into a retro icon, this limited-run "Bandit" build blends nostalgia with brute force in a way few revivals manage.

By Verdad Gallardo | 2026-04-21 13:57:02


VIEW MORE
story-7
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked

Slideshow: Cadillac didn't just crash the high-performance luxury vehicle party, it showed up loud, supercharged, and occasionally a little unhinged...

By Pouria Savadkouei | 2026-04-16 10:05:15


VIEW MORE
story-8
Top 10 Most Powerful Chevy Trucks Ever Made!

Slideshow: Top ten most powerful Chevy trucks ever made

By | 2026-03-25 09:22:26


VIEW MORE
story-9
Hennessey's New Supercharged Silverado ZR2 Has 700 HP

Slideshow: Hennessey has turned the Silverado ZR2 into a 700-hp off-road monster with supercharged V8 power and a limited production run.

By Verdad Gallardo | 2026-03-24 18:57:52


VIEW MORE